Installation manual

AQUAERO 5

After assigning a controller to an output

outputoutput

output and configuring output specific

parameters like minimum power or start boost, the signal chain from sensor

via controller to output is completely configured.

5.1. Sensors

5.1. Sensors5.1. Sensors

5.1. Sensors

The following sensors are available:

– Temperature sensors

– Virtual sensors: Can be used to determine maximum, average or

minimum value of up to three temperature sensors.

– Software sensors: These values can be written into the device using the

aquasuite software. They can for example be used to transmit the

current CPU temperature to the aquaero 5 and use this value for

controlling fan speeds.

– Flow sensors

– Power measurement: Allow calculating power dissipation from a

temperature difference and corresponding flow rate.

5.2. Controllers

5.2. Controllers5.2. Controllers

5.2. Controllers

The following controller models are available:

– Curve controllers: Adjustable control curves, defined by 16 temperature

values and corresponding output values.

– Target value controllers: Automatic output adjustment to match a

predefined target temperature.

– Two point controllers: Simple on/off controller, using a lower and upper

temperature limit.

– Preset values: Constant preset values.

– RGB LED controller: Temperature-dependent color gradient controller

for the RGB LED output.

5.3. Outputs

5.3. Outputs5.3. Outputs

5.3. Outputs

The following outputs are available:

– Fans

– Power outputs

– LED outputs

Gelliehäuser Str. 1, 37130 Gleichen