Installation manual

AQUAERO 5

Pin assignment: Pin 1: GND

Pin 2: SDA

Pin 3: SCL

Pin 4: +5 V

4.7. Connector „Tacho“

4.7. Connector „Tacho“4.7. Connector „Tacho“

4.7. Connector „Tacho“

Depending on configuration, the aquaero 5 can generate a speed signal

which is available for processing through this connector. This speed signal

can for example be configured to cease function upon alarm events and

thereby relay the alarm status to a fan connector of your motherboard.

Functionality of the speed signal can be configured using the menu entries

“Alarm” and “Timer”. For details on how to configure your motherboard to

process the speed signal, please refer to the manual of your motherboard.

4.8. Connector „Sensors“

4.8. Connector „Sensors“4.8. Connector „Sensors“

4.8. Connector „Sensors“

Connector for up to 8 temperature sensors. For compatible sensors, please

refer to chapter 4.14.

Pin assignment: Pin 1/2: Sensor 1

Pin 3/4: Sensor 2

Pin 5/6: Sensor 3

Pin 7/8: Sensor 4

Pin 9/10: Sensor 5

Pin 11/12: Sensor 6

Pin 13/14: Sensor 7

Pin 15/16: Sensor 8

4.9. Connector „USB“

4.9. Connector „USB“4.9. Connector „USB“

4.9. Connector „USB“

This connector is used for USB communication to the PC and for standby

power supply. Take special care to make sure the pin alignment matches

your motherboard!

Pin assignment: Pin 1 +5 V

Pin 2 D-

Pin 3 D+

Pin 4 GND

Pin 5 GND

Gelliehäuser Str. 1, 37130 Gleichen