Use and Care Manual

AQUASURE FORTITUDE V SERIES

SYSTEM FILTERS:

AS-F120PS / AS-F110PS

• AF-PS30-4520 / AF-PS30-4510 - 30 Micron Pleated Sediment Filter X 1

AS-120CB / AS-F110CB

• AF-CB5-4520 / AF-CB5-4510 - 5 Micron Carbon Block Water Filter X 1

AS-120SCP / AS-F110SCP

• AF-SCP-4520 / AF-SCP4510 - Sediment and Carbon Dual Purpose Water Filter X 1

AS-220PSCB / AS-210PSCB

• AF-PS30-4520 / AF-PS30-4510 - 30 Micron Pleated Sediment Filter X 1

• AF-CB5-4520 / AF-CB5-4510 - 5 Micron Carbon Block Water Filter X 1

AS-220SCPKDF / AS-210SCPKDF

• AF-SCP-4520 / AF-SCP-4510 - Sediment and Carbon Dual Purpose Water Filter X 1

• AF-KDF-4520 / AF-KDF-4510 - GAC/KDF Bacteria Inhibiting Specialty X 1

II. System Operation Parameter and Installation checklist

IMPORTANT! The following condition for feed water supply must be met or warranty will be

void and manufacturer assumes no responsibility for damage to system or property.

1. Water Temperature Parameter

• Maximum: 100º F (37.8º C)

• Minimum: 40º F (4.4º C)

2. Water Pressure Parameter

• Maximum: 75 PSI (5.98 kg/cm2)

• Minimum: 20 PSI (1.41 kg/cm2)

3. pH Parameter

• Maximum: 10

• Minimum: 5

4. Pre-install environment checklist

• Do not use with water that is microbiologically unsafe or of unknown quality without

adequate disinfection before or after the system.

• Filtration system must not be installed at an area where it is exposed to direct sunlight

and must be protected against freezing and extreme heat.

• To prevent possible water damage, housing should be replaced every 4 years.