Use and Care Manual

8
www.AQUASUREUSA.com
818 N Mountain Ave #203c, Upland, CA 91786 | 800.661.0680 | [e-mail]
4. Drilling Stainless Steel
• Use a hole punch and hammer to mark the location of where you want to install the faucet. Keep
your taps short and control until a dent is visible, this will help keep your drill bit seated when start
drilling.
• Apply lubricant to the drill area as drilling at high speed will create a lot of heat which can cause the
metal to warp or burn.
• Using the ¼” (6mm) drill bit, at half speed to drill the hole. This would help prevent it from
overheating.
• Switch to 7/16” (11 mm) drill bit and do the same to widen the hole.
• Once the hole is drilled, use the le to smooth out the edges and wipe away the shaving.
• Clean The Area
• Discard paper towels and newspaper used in the sink and below sink. Be very careful not to drop
any shavings in the sink or on the oor as they will oxidize and stain surfaces very quickly.