Use and Care Manual
5
AQUASURE PREMIER SERIES
5. System Dimensions & Specications
IMPORTANT! Please make sure there is sufcient space for the system to be installed properly. It is
best to rst place the system in the space to see if there is room for the system to be mounted and
installed properly. Do not install the system in an area where it is exposed to extreme hot and/or cold
weather or under direct sunlight.
WARNING: It is recommended to mount the system on the wall with the correct screws appropriate
for the mounting location. If mounting the system is not an option, please make sure system is installed
in a space with secure footing. Improper placement of the system may cause the system to tip over and
break due to the added weight of the water.
• System Dimensions: 15”w x 5.25”d x 15”h
• System Weight: 8 lbs (3.6kg)
• Tank Dimensions (with Valve): 11.3”d x 16.75”h
• Tank Capacity: 1.9 - 3.2 gal. (7.2 - 12.1L)
• Tank Weight: 6.6 lbs (Empty) / 40 lbs (Full - Varies by water pressure)
III. Feed Water Adapter with 3/8” and 1/2” Connection Setup
Note: The feed water adapter is setup to work with either 3/8” or 1/2” cold water line. Please make
sure the o-ring is properly placed before installation.
1. Converting 3/8” connection to 1/2” (See Diagram B)
• Install the 3/8” to 1/2” outlet converter to the adapter by rotating clockwise until tightened.
• Install the 3/8” to 1/2 inlet converter to the adapter by rotating counter-clockwise until tightened.
Please make sure
there are O-rings
inside the connector
Rotate clockwise to tighten
Rotate counter-clockwise to tighten
1/2” Connection
3/8” Connection
Dia. B
Instruction continues on the next page