Installation Guide

AQUASURE FORTITUDE PRO SERIES

STEP 4. Attaching the Water Supply Pipe to the Pre-Filter

1. Wrap the 1” male threaded ttings that will be used to connect the

plumbing to the pre-lter with ve (5) to six (6) wraps of Teon tape.

2. Attach the 1” male threaded tting from the incoming water supply

plumbing to the IN port and OUT port of the pre-lter system.

Note: Use the 1” to 3/4” inch male adapter for 3/4” plumbing

STEP 5. Installing the Pre-Filter Cartridge

1. Unwrapp the lter cartridge and place it inside the

housing. Make sure the lter is centered on the stand

pipe located inside the housing at the base.

2. Screw on the housing with the lter inside and

screw onto the corresponding head by turning it

counterclockwise using the supplied housing wrench.

Note: Make sure the o-ring is inside the housing

and do not over tightening the housing.

STEP 3. Mounting the Pre-Filter

1. Position the system on the wall at the desired mounting

location with minimum of six (6) inches of ground clearance

from the oor to the base of the system.

2. Using a pen or pencil and mark the mounting hole on the

back of the bracket onto the wall.

Note: Please make sure the bracket mount is leveled using

a leveling tool to ensure evenly distributed stress on the

bracket. Make sure the mounting point is position on a stud

to properly secure the bracket.

3. Mount the system onto the wall using the provided Lag Bolts

and Washers.