Installation Guide

Tel: [phone]
9
AQUASUREUSA.com
STEP 6. Attaching the Water Supply Pipe to the Treatment System
STEP 7. Mounting the Valve Body onto the Media Tank
1. Place the blue gasket in between the valve body
and the adapter. Screw the adapter into the
valve body.
2. Apply the same procedure to all three openings.
Note: Make sure the o-ring is inside the housing and do not over tightening the housing.
1. Apply a small amount of lubricant onto the
o-ring of the valve body. (Do not apply lubricant
on the thread.)
2. Lubricate the riser tube located on the opening
of the media tank. Make sure the riser tube is
ush with the top of the tank.
3. Install the upper basket on the bottom of the
valve by lining up the tabs, pressing in, then
turning the basket counterclockwise to lock it in
place.