Specifications

Note: When removing the head there may be some spillage of water.
It is recommended to have a towel handy.
Quick Disconnect Procedure:
1. Uplug unit from electrical power source.
2. Move the Bypass lever from the “Service” position to
the “Bypass” position
3. Turn the Manual Regeneration knob to the
“Backwash” position to relieve the pressure.
4. Remove the drain line from the back of the Control
Head.
5. Remove the Brine Line from the control valve using
a 5/8 wrench.
6. Remove the two clips between the bypass and the
control valve using a screwdriver or a 1/4” nut driver.
Then gently slip the unit off of the bypass.
7. Remove the two valve mounting pins at the base of
the valve. Then gently rock the valve from front to
back while lifting up.
8. To reinstall the control valve, center the control
valve over the distributor tube and gently push
down while gently rocking the valve front to
back.
9. Sanitize system when nished. (see page 3 for
instructions on sanitizing.)
Maintenance Information
8