Manual
In any operational mode, press the (12V TRIGGER) key to activate. Press again to deactivate.
Aquatic AV understands the need for more exible remote applications. With the AQ-MP-5UBT
Media Player Aquatic AV has provided two independent 12V ‘accessory’ trigger, activated from the
RF wireless remote. These could activate any 12V based device like 12V lights or 12V motors.
6.1 External 12V Triggers
Load on External Trigger should not exceed 350mA.
Aquatic AV strongly recommend you speak to our technical service staff or your local Aquatic AV dealer if you are
considering using this feature.
Wiring a Single Pull Single Throw (SPST) Relay
The SPST is necessary to protect the stereo in systems
with multiple ampliers. The AQ-MP-5UBT remote and
trigger wire provide 350mV. While this enough to power
a single amplier, complex systems with multiple ampli-
ers will require a SPST relay.
Position 30: requires 12VDC from the main power
source (12V battery, power supply etc). This should be
the same power source that is powering your stereo.
Position 85: this is where you connect your ground from
your power source (12V battery, power supply, etc.) This
should be the same ground reference as your stereo.
Position 86: position 86 is triggered 12V, and is sent when your stereo is powered on.
For Aquatic AV stereos position 86 can be connected to either the blue remote wire in the harness
or the brown 12V trigger on the rear of the unit. The differences are below:
Blue (recommended): The blue (remote wire) provides a 12VDC output when the stereo is pow-
ered on. Meaning as soon as the stereo is powered on the blue wire sends 12VDC through the
relay powering on the amplier.
Brown: the brown (12V Trigger) provides 12VDC output when it is triggered via the lightning
bolt icon on the faceplate or handheld remote. This setup is more advantageous is a more com-
plex system with several zones, as it gives you control of when an amp is on or off.
Position 87: this is the 12VDC output that you will provide 12VDC to the remote turn on to the
ampliers in your system.
6.2 Connecting Multiple Amplifiers or High Current Draw Lighting Systems
87
87
85
30
86
Triggered
12V DC from
stereo (Blue or
Brown wire)
Main 12V DC
input (fused)
Common
Ground
12V DC output for amplifier
Additional Features Media Player AQ-MP-5UBT
14www.aquaticav.com