Instructions / Assembly

Aquatic • 8101 E. Kaiser Blvd. • Anaheim, CA 92808 • [phone] • FAX [phone] • www.aquaticbath.com
— 3 —
Installation Instructions
Shower Stalls/Tub-Showers
Fax on Demand # 1900
Aquatic products may be specified as Lasco Bathware.
2
NOTE: Use of foundation material is highly recommended for firmer bottom support.
Prepare a foundation material mix (industrial plaster, mortar mix; mix to a doughy consistency). Place three or four mounds on the subfloor around but
away from drain hole. The mounds should be high enough so that when the unit is set, it will cause the foundation material to displace and spread.
For showers, refer to Diagram 4A; for tub-showers, refer to Diagram 4B.
4B
5 6
8
Check for level.
INSTALLATION PROCEDURE, CONT.
4A
2
Place the unit into framing with drain fitting over and onto waste
pipe with skirt firmly on the floor.
7
Assure waste pipe protrudes well into drain fitting.
Maintain proper floor slope towards drain.
Pre-drill pilot holes. Fasten panel to framing at every stud and eight inches
vertically through nailing flange.
When other than cementitious backer board plaster is to be used, furring strips
as thick as nailing flanges are recommended for installation on studs above the
installed Aquatic unit to assure walls will be flush. 100% silicone with mildew
resistant properties should be applied between the backer board and horizontal
surface of unit. Then finished wall materials can be applied.