Instructions / Assembly

Customer Service: 800.945.2726 • aquaticbath.com
— 2 —
Installation Instructions
Shower Stalls/Tub-Showers
Aquatic products may be specified as Lasco Bathware.
6“x12”
B
A
6“ Dia.
B
A
A
A
B
B
C
C
A
B
C
A
B
C
Note: If fire-rated alcove is required, approved finish material must be in place prior to unit installation to meet fire safety requirements of local
building codes and/or FHA/HUD Minimum Property Standards.
Check dimensions. Make sure framed-in alcove is of proper size, square and plumb.
For showers, refer to Diagram 1A; for tub-showers, refer to Diagram 1B.
1A 1B
2A
INSTALLATION PROCEDURE
2B
If mounting fittings — from stable reference points (back wall studs, floor) measure the locations of spout and valves. Note measurements below.
For showers, refer to Diagram 2A; for tub-showers, refer to Diagram 2B.
Mark fitting locations. (Refer to measurements from step 2.) Using a
hole saw (fine tooth or abrasive grit cutting edge), make necessary
openings for filler and valves, drilling from inside (smooth side) out.
3
Note measurements here:
Tub Filler: ________________________________
Valve: ___________________________________
Shower Arm: _____________________________
Valve: ___________________________________
(Mark dimensions only if shower arm is plumbed
within bath fixture wall area.)