Instructions / Assembly

Customer Service: 800-945-2726
— 3 —
Installation Instructions
Remodeline (Sectional Units)
Aquatic products may be specified as Lasco Bathware.
Gel-coated and Acrylic Surfaces
To properly prepare the surface, clean the application area with a solvent, such as mineral spirits or paint thinner. After applying solvent, always wipe the
surface dry with a clean, non-contaminated cloth or towel. Never let solvent air dry or evaporate; always wipe it clean.
General Cleaning Cautions
n Clean the application surface immediately before caulking.
n Use cleaning solvents in a well-ventilated area, following all safety precautions and instructions listed on the product label.
n Do not use detergent or soap to clean the application surface; silicone sealants will not adhere to soap residue or scum.
Silicone should be inspected periodically and reapplied as necessary to prevent any water related issues. If mold or mildew is present, clean the
area with a disinfectant and apply rubbing alcohol.
Follow the procedures below for application of silicone and to ensure proper maintenance:
1. Apply silicone/caulk remover to soften the sealant material (silicone/caulk or grout) that is being replaced.
2. Peel out the old sealant material using a soft putty blade or awl (non-metal utensils).
3. Apply a strip of painter’s masking tape along the inside edge of each side of the joint/s where silicone sealant will be applied.
4. Apply silicone to the joint/s and smooth over with finger or caulking tool.
5. Remove tape strips along joint edges after the silicone is applied and smoothed out, while the silicone is still wet.
NOTE: Allow silicone to cure for 24 hours (normal cure time) before using bath or shower. Humidity affects the curing process and different geographical
areas experience varying degrees of humidity. Refer to silicone manufacturers’ instructions for additional information related to curing times.
CAUTION: When using any cleaning or polishing materials, make sure to read and follow all package instructions carefully. Wear rubber gloves
at all times and avoid contact with eyes, skin, clothing, rugs and furnishings. Make sure all residues are rinsed off thoroughly.
DIAGRAMS
Diagram 1
Diagram 2