OWNER’S MANUAL & INSTALLATION GUIDE Serenity DriftBath ™ INSTALLER: This booklet must be given to the product owner. Read all instructions before proceeding. All specifications are ± 3⁄8’’ and are subject to change without notice. Dimensions listed in inches.
Serenity DriftBath™ Owner's Manual & Installation Guide TABLE OF CONTENTS PRODUCT WARRANTY REGISTRATION INFORMATION IMPORTANT SAFETY INSTRUCTIONS 4–5 DRIFTBATH USER INFORMATION 6 FCC CONSUMER INFORMATION 6 INSTALLATION INSTRUCTIONS Pre-Installation Instructions Structural Preparation Framing Diagrams Deck Cutouts Plumbing Electrical Installation DriftBath with Chromatherapy LED Lights 7–8 9 10 11 12 12 13 OPERATION INSTRUCTIONS Bath-side On/Off Controls 14 TUB CARE Maintenance Repair 15 15 WA
Serenity DriftBath™ Owner's Manual & Installation Guide AQUATIC Product Warranty Registration Information Thank you for choosing an Aquatic bath. You have chosen one of the finest bath products in the industry. Aquatic supports your purchase with strong commitments to quality and customer satisfaction. IMPORTANT! To activate Product Warranty please register with Aquatic. Your product warranty must be registered and confirmed with Aquatic through the Serial Number on your unit.
Serenity DriftBath™ Owner's Manual & Installation Guide IMPORTANT SAFETY INSTRUCTIONS WARNING: When using this unit, basic precautions should always be followed. Failure to follow these instructions could result in personal injury, electric shock, or fire. READ AND FOLLOW ALL INSTRUCTIONS: • WARNING: Risk of lethal electric shock. To reduce risk of electric shock, connect only to circuits protected by a Ground-Fault Circuit-Interrupter (GFCI) or Residual Current Device (RCD).
Serenity DriftBath™ Owner's Manual & Installation Guide IMPORTANT SAFETY INSTRUCTIONS DANGER! TO REDUCE THE RISK OF INJURY: 1. Do not permit children to use this unit unless they are closely supervised by an adult at all times. Supervision is also required when whirlpool bath is used by an elderly or handicapped individual. 2. The water in a whirlpool should never exceed 40°C (104°F). Water temperatures between 38°C (100°F) and 40°C (104°F) are considered safe for a healthy adult.
Serenity DriftBath™ Owner's Manual & Installation Guide DRIFTBATH USER INFORMATION PLEASE NOTE: No servicing of this product should be done by the user. There are no user serviceable parts. All controls are located in the control recesses on the lip of the tub. These are the only controls that should be used by the consumer. Do not change or alter any of these controls under any circumstances. Motors are self-lubricating -- No lubrication required.
Serenity DriftBath™ Owner's Manual & Installation Guide INSTALLATION INSTRUCTIONS READ ALL INSTRUCTIONS CAREFULLY BEFORE INSTALLATION PRE-INSTALLATION PROCEDURES PLEASE NOTE: THE MANUFACTURER ACCEPTS A +3⁄8” VARIANCE. THERE ARE VARIATIONS ON EACH TUB AND SPECIFICATIONS ARE SUBJECT TO CHANGE AS WE IMPROVE UPON OUR PRODUCT AS REQUIRED. THE DIMENSIONS NEEDED FOR SITE PREPARATION AND STRUCTURE BUILDINGS SHOULD BE MEASURED FROM THE TUB; AQUATIC ASSUMES NO RESPONSIBILITY FOR PREPARATORY WORK.
Serenity DriftBath™ Owner's Manual & Installation Guide INSTALLATION INSTRUCTIONS QUIETNESS OF OPERATION: Aquatic has engineered their baths from base to lip to ensure quality, value, functional design, and maximum bathing comfort. However, installation is accountable for as much as 50% of a tub’s operating quietness. Please ensure the following: • The floor structure is adequate to support the installation.
Serenity DriftBath™ Owner's Manual & Installation Guide INSTALLATION INSTRUCTIONS STRUCTURAL PREPARATION Note: The bath should remain in its shipping carton until time of installation. 1. Literature dimensions are for reference only. Installation dimensions should be taken directly from the tub. An unobstructed access panel of 16” x 16” minimum must be provided at the pump end of the tub allowing sufficient clearance to make final connections and for servicing the pump and power panel.
Serenity DriftBath™ Owner's Manual & Installation Guide INSTALLATION INSTRUCTIONS FRAMING DIAGRAMS 1. Protect interior of tub throughout installation process. ELECTRICAL 2. Framing andINSTALLATION: supports will vary according to the model and type of installation selected. 3. Please refer back to the unit's Technical Data sheet for specific dimensions located at www.aquaticbath.com.
Serenity DriftBath™ Owner's Manual & Installation Guide INSTALLATION INSTRUCTIONS DECK CUTOUTS A paper template will be enclosed with all rounded-edged models. Use the directions on the paper template for cutout dimensions. If the paper template has been lost or needs replacement, please contact Customer Service at: 800.945.2726. USING THE CUTOUT TEMPLATE Draw a center line horizontally and vertically on a 1” thick plywood deck.
Serenity DriftBath™ Owner's Manual & Installation Guide INSTALLATION INSTRUCTIONS PLUMBING 1. After securing tub in place, normal waste and overflow, water spout and valves are installed per normal plumbing procedures, in accordance with all national, state and local standards. 2. Install standard 11⁄2” trap to drain and overflow. Before proceeding, make final operational check by filling tub with water to overflow and operate pump for 5 minutes.
Serenity DriftBath™ Owner's Manual & Installation Guide INSTALLATION INSTRUCTIONS DRIFTBATH WITH CHROMATHERAPY LED LIGHTS KEYPAD LIGHT CONTROL BOX PUMP CONTROL BOX UP/HAUT UP/HAUT B C W/D KEYPAD AUX OUTPUT INTPUT OUTPUT INTPUT W/D KEYPAD AUX NEMA PLUG PUMP LED LIGHTS NEMA PLUG MAIN BREAKER PANEL 120V-240V/60Hz NEMA PLUG IMPORTANT: 15A/120V DOUBLE POLE BREAKER WITH GROUND FAULT CIRCUIT INTERRUPTER CLASS "A". (TWO 15 AMPS/120 VOLTS CIRCUIT.
Serenity DriftBath™ Owner's Manual & Installation Guide OPERATION INSTRUCTIONS BATH-SIDE ON/OFF CONTROLS KeyPad Functions 1: On/Off Pump 1st Press: The pump starts 2nd Press: The pump stops 2: Chromatherapy 1st Press: Turn on the light in white 2nd Press: Rainbow cycle – Low speed 3rd Press: Rainbow cycle – High speed 4th Press: Turquoise 5th Press: Blue 6th Press: Magenta 7th Press: Red 8th Press: Orange 9th Press: Yellow 10th Press: Green Electronic Keypad 11th Press: Back to Rainbow cycle – Low speed
Serenity DriftBath™ Owner's Manual & Installation Guide TUB CARE MAINTENANCE DriftBath Cleaning Before tub is used, remove all debris and clean tub. DO NOT USE ABRASIVE CLEANERS ON THE ACRYLIC FINISH. Use a non-abrasive detergent and rinse well after cleaning. • • • • Fill the tub with HOT water to a level 2” above the highest water port.
Serenity DriftBath™ Owner's Manual & Installation Guide WATER QUALITY CHEMICAL & WATER QUALITY Owners of fill and drain whirlpool bathtubs need to know basic information concerning water quality, how it affects the performance and enjoyment of the operation of their tubs, and steps that can be taken by the owner to correct related problems. Important issues are the microbiological and chemical quality of the water. 1.
Serenity DriftBath™ Owner's Manual & Installation Guide WATER QUALITY Iron - Iron is found in many natural waters especially from wells. Iron in water can also result from the corrosion of piping in the water supply system, such as cast iron mains or galvanized steel service lines, or galvanized piping in the home water system. High iron levels may result in the formation of brown stains in the vicinity of the faucet outlets of various fixtures in the home.
Serenity DriftBath™ Owner's Manual & Installation Guide TROUBLESHOOTING GUIDE WARNING: Always turn off power at the main electrical service panel when servicing your tub. SYMPTOMS POSSIBLE PROBLEMS SUGGESTED SOLUTIONS Motor does not start 1) GFCI or circuit breaker in OFF position. 1) Reset GFCI (if optional heater is installed, be sure there are two GFCI circuits.) 2) Contact your electrician. 3) Contact Aquatic. 4) Contact Aquatic. 5) Contact Aquatic. 6) Check and reconnect if needed.
Serenity DriftBath™ Owner's Manual & Installation Guide REPLACEMENT PARTS MAP 1. 2. 3a. 4. 1a. 1b. 1c. 1d. 1e. 2a. 3. 3b. 4f. 4e. 4a. 4b. 4c. 4d. 5. 5a. 6. 6a. 6c. 6b. 7. 7b. 7e. 6d. 7d. 7c. 8a. Aquatic 7a. 8b.
Serenity DriftBath™ Owner's Manual & Installation Guide REPLACEMENT PARTS LIST ILLUSTRATION NO. PART # DESCRIPTION 1A. 8406010FTG 1” 90 DEG SLIP ELBOW 1B. 8100PIPE 1” PVC PIPE 1C. 8437211FTG 1.5” X 1” REDUCER FITTING 1D. 8500MANIFOLD DRIFTBATH MANIFOLD; 8 PORT 1E. 8401015FTG TEE FITTING; 1.5”S X 1.5”S X 1.5”S 2A. 8500PADCL KEYPAD KIT;TMS TIMER/LIGHT; CL 3A. 5982MANIFOLD MAINFOLD; 4 PORT 3B. 8429010FTG 1” COUPLING FITTING 4A.
Serenity DriftBath™ Owner's Manual & Installation Guide Aquatic Limited Warranty Serenity DriftBath™ Limited Warranty For Original Consumer For Household Usage WHAT PRODUCTS ARE COVERED Structures and surface finishes on the tub and their support systems including equipment, components, attachments and plumbing equipment. Different warranty periods apply to specific components.
Customer Service: 800.945.2726 • aquaticbath.com 8MANDBTH | 01.