Specification

Customer Service: 800.945.2726 • aquaticbath.com
TECHNICAL SPECIFICATIONS
MARRATTA
60 x 43
1
⁄4 x 20
1
⁄4 inches
Builders’ Choice Series
42"
43 1/4"
60"
19"
1 1/4"
1
2
3
4
5
A
13 5/8”
43"
52"
23"
26"
52˚
B
SUMP DATA inches
Capacity to
Overflow
gal
Min. Operat-
ing Capacity
gal
WIDTH @ centerline DEPTH @ centerline
Top Bottom Top Bottom
72 52 52 43 26 23
DIMENSIONS inches
Width
Overall / Net
Depth
Overall / Net
Height
Overall / Net
Skirt
Height
60
43
1
⁄4 / 42 20
1
⁄4 / 19 19
ELECTRICAL DATA
Component Specification Requirement
Pump
5 AMP; 120 V
15 AMP; 120V, separate circuit;
Class A GFCI
Optional Heater
(whirlpool model)
1.5KW; 12 AMP; 120 V
15 AMP; 120V, separate circuit;
Class A GFCI
Heated Blower 5 AMP; 120 V
15 AMP; 120V, separate circuit;
Class A GFCI
Each air bath is equipped with an air heating system to raise the temperature of the air entering
the bath. This air temperature will be lower than the bathing temperature of the water, but will
help reduce rapid decrease in water temperature. In addition, the air coming from the air jets
will feel cool against the skin. This system does not heat the water.
FEATURES Dimensional Tolerance ± 3⁄8”.Dimensions needed for site preparation should be measured from the unit.Aquatic assumes no responsibility for preparatory work.
Type and Model # Material Jets Pump Heater Controls Drain
Pkg. Wt.
lbs
Soaker #7260420 Cast Acrylic 0 – – – LH or RH 127
Whirlpool #7260421 Cast Acrylic 8 63 GPM
1.5kW inline
(optional)
Pneumatic LH or RH 177
Air Bath #7260420A Cast Acrylic 0 – Inline Pneumatic LH or RH 157
PLUMBING DIMENSIONS inches
A B
Drain
to Overflow
Drain
Diameter / Clearance
2 9
3
⁄8 13
5
⁄8 2 / 1
3
⁄8
NOTES:
1) Where applicable, utilize cut-out templates packed
with unit for deck cutouts.
2) 16 x 16 minimum access required at pump/blower location(s).
Rev. 05.31.18