Full Product Manual

6 Aquatic
Builders’ Choice Air Owner's Manual & Installation Guide
TOOLS REQUIRED FOR INSTALLATION: (NOT INCLUDED)
INSPECTION BEFORE INSTALLATION
1. Inspect the Aquatic air bath to ensure it is the correct model number, size, color, and has all features, options and
accessories originally ordered.
2. If damage or shortage has occurred, notify your distributor, freight carrier, or Aquatic Customer Service Center at
[phone].
NOTICE: Under no circumstances should a damaged or defective bath be installed without prior factory approval.
Neither Aquatic nor the distributor will be responsible for removal or reinstallation costs should replacement of the bath
be necessary.
3. This air bath is factory-assembled, complete with blower, controls and plumbing. DO NOT lift or support unit using
plumbing lines or any part of circulation system. DO NOT relocate or otherwise modify any part of the factory-
installed air circulation system, as this may affect the performance or safe operation of the air bath and will void
all warranties.
4. Inspect air bath unit and air circulation system carefully before installing. Water test the unit before installation.
If any damages or defects are observed, DO NOT INSTALL. Notify your distributor immediately.
5. Make certain the air tube that is connected to the blower is also connected to the on/off button nipple under the deck
in order for the system to function.
WATER TEST: PLACE THE TUB IN AN AREA WHERE IT MAY BE DRAINED AFTER TESTING.
1. Fill the tub with water to the overflow and allow to stand for a few minutes.
2. Plug in blower cord and run blower for 10 minutes.
3. Inspect the tub completely. Any defect must be reported to Aquatic prior to installation in order to have it covered by
warranty.
4. Check to ensure that your installation will conform to all applicable codes and secure necessary permits. All electrical
and plumbing connections should be made by qualified electricians and plumbers.
5. This unit has been factory-tested prior to shipment for leakage and proper operation of the system. However, in transit
and handling, the half-union blower may become loose. Make sure it is hand-tight.
Aquatic will not be liable for any defects or damages, including incidental or consequential damages that could have
been discovered or prevented by following these procedures for storage, handling and inspection.
PRE-INSTALLATION REQUIREMENTS
READ ALL INSTRUCTIONS CAREFULLY BEFORE INSTALLATION
3/16"
Drill Bit
Phillips Screw Bit
Tape Measure
Safety Glasses Hammer Level
#10 x 1 ½" self –tapping
washer head screw
OR 1 ½" Galvanized roofing nail
Pencil
Drill