Instructions / Assembly

ManualsBrandsAquatic ManualsBathAccessible Diagonal Tile AcrylX 36 in. x 36 in. x 76 in. 4-Piece Shower Stall with Right Seat and Grab Bars in White

— 1 —

Aquatic • 8101 E. Kaiser Blvd. • Anaheim, CA 92808 • (800) 877-2005 • FAX (714) 998-5340 • www.aquaticbath.com

Installation Data

Freedomline 4-Piece Showers

F1364P, F1424P*, F1604P

Fax on Demand # 1163

Aquatic products may be speciﬁed as Lasco Bathware.

(Pre-drilled holes, soap dish and

seat as shown are optional)

ADA/ANSI COMPLIANT BARRIER-FREE SHOWER STALLS

For roll-in showers with beveled thresholds, build up or recess the bathroom floor 3/4 inch less the thickness of the finished floor,

ensuring that the finished floor meets the base of the bevel at the threshold.

It is recommended that the bathroom floor outside ADA clear floor space be designed with a floor drain to alleviate any water over

spray that may escape the shower stall.

*NOTE: Model F1424P is compliant with California Title 24 only, not ADA/ANSI.

7/16” (11 mm)

Socket Wrench

Phillips Screwdriver

3/16” Drill Bit

Phillips Screw Bit

#8 X 1”

Pan Head Screws

100% Mildew Resistant

Silicone Sealant

Level

Hammer

Tape Measure

Drill

Tools Needed

Items Included

Summary of content (8 pages)

PAGE 1
Installation Data Aquatic products may be specified as Lasco Bathware. Freedomline 4-Piece Showers F1364P, F1424P*, F1604P Fax on Demand # 1163 ADA/ANSI COMPLIANT BARRIER-FREE SHOWER STALLS For roll-in showers with beveled thresholds, build up or recess the bathroom floor 3/4 inch less the thickness of the finished floor, ensuring that the finished floor meets the base of the bevel at the threshold.
PAGE 2
Installation Data Freedomline 4-Piece Showers F1364P, F1424P*, F1604P Fax on Demand # 1163 Aquatic products may be specified as Lasco Bathware. NOTICE: Please inspect the unit thoroughly before installation to make sure it has not been damaged during transportation. Under no circumstances should a damaged unit be installed. Neither Aquatic nor the distributor will be responsible for removal or reinstallation costs should a replacement be necessary due to installation of a damaged unit.
PAGE 3
Installation Data Aquatic products may be specified as Lasco Bathware. Freedomline 4-Piece Showers F1364P, F1424P*, F1604P Fax on Demand # 1163 INSTALLATION INSTRUCTIONS, CONT. 1 2 D C B 6“Dia. A Disassemble wall set from base as shown. Set walls aside. CAUTION: While disassembling, secure walls to prevent damage.
PAGE 4
Installation Data Aquatic products may be specified as Lasco Bathware. Freedomline 4-Piece Showers F1364P, F1424P*, F1604P Fax on Demand # 1163 INSTALLATION INSTRUCTIONS, CONT. 7 8 Remove base and back wall from framing. Install drain assembly per manufacturer’s instructions. Spread a bed of foundation material around drain extending to perimeter of shower floor. (Drain box-out should be back filled with foundation material. Do not allow foundation material to enter drain pipe.
PAGE 5
Installation Data Aquatic products may be specified as Lasco Bathware. Freedomline 4-Piece Showers F1364P, F1424P*, F1604P Fax on Demand # 1163 INSTALLATION INSTRUCTIONS, CONT. 13 14 Check for level. Pre-drill pilot holes and fasten panel to framing at every stud and eight inches vertically through nailing flange. 15 16 Silicone holes before inserting hardware. Fasten bolts and wipe off excess silicone. Attach grab bar flanges to left wall and snap grab bar cover over flanges.
PAGE 6
Installation Data Aquatic products may be specified as Lasco Bathware. Freedomline 4-Piece Showers F1364P, F1424P*, F1604P Fax on Demand # 1163 INSTALLATION INSTRUCTIONS, CONT. 19 20 Silicone holes before inserting fasteners. Attach grab bar to back wall and snap grab bar cover over flange. Wipe off excess silicone. Silicone front edge, avoiding weep channel. Place right wall into position. Front reveal on the sidewall and sump should be flush. Check for level.
PAGE 7
Installation Data Aquatic products may be specified as Lasco Bathware. Freedomline 4-Piece Showers F1364P, F1424P*, F1604P Fax on Demand # 1163 CLEAN-UP CAUTION: DO NOT USE heat or solvent based cleaning fluids. NOTE: Do not remove warranty/maintenance adhered label. Warranty/User maintenance label must be left for occupant (Required by ANSIZ124). 1. Prevent staining. Remove all debris before plumbing leak test. Drain and wipe clean immediately after the inspection process.
PAGE 8
Customer Service | Technical Services | Warranty Services 1521 No. Cooper, Ste.