Installation Guide

Thank you for choosing an Aquatic bath. You have chosen one of the finest bath products in the industry.
Aquatic supports your purchase with strong commitments to quality and customer satisfaction.
Please read and follow all of the instructions contained in this Owner’s Manual before installing, operating or
maintaining your whirlpool. In addition, you should continually refer to these instructions during the life of your
tub. Failure to comply with these instructions may invalidate your warranty. If you have questions concerning installation,
operation, maintenance or any other aspect of your tub, please contact CUSTOMER SERVICE: 800.945.2726
(The Troubleshooting Guide on page 21 may be helpful in answering some of your questions.)
NOTE: The installation and service of your Tub should be performed ONLY by a licensed electrician and plumber.
AQUATIC Product Warranty Registration Information
Customer Service: 800.945.2726 • aquaticbath.com
IMPORTANT!
To activate Product Warranty please register with Aquatic.
Your product warranty must be registered and confirmed with Aquatic through
the Serial Number on your unit. To register, please contact Aquatic.
800.945.2726 • www.aquaticbath.com/register
This product MUST BE WATER-TESTED and inspected prior to installation
or warranty will be voided. [See TO INSPECT on page 6.]
Neither Aquatic nor the distributor will be responsible for removal or reinstallation
costs should replacement of the bath be necessary.
PLEASE CHECK ENTIRE UNIT FOR ANY DAMAGE.
If it appears damaged, do not install. Contact your Aquatic Distributor immediately.
Aquatic warranty does not cover damage that occurs in transit.
IMPORTANT!
Model & Serial Number Location
The tub model and serial numbers are
located above the pump area on the
backside of the bathtub. An access panel
should be placed by the installer at this
location.