Full Product Manual

Aquatic 11
Builders' Choice Owner's Manual & Installation Guide
ELECTRICAL CONNECTIONS
READ AND FOLLOW ALL INSTRUCTIONS
All local, state and national electrical codes must be observed by a licensed electrician in connecting power
to the Aquatic Whirlpool.
Important Safety Instructions
WARNING - When using electrical products, basic precautions should always be observed, including the following:
1. READ AND FOLLOW ALL INSTRUCTIONS.
2. Circuit - A separate circuit (not to supply any other electrical devices) is required as follows: Each electronic
component (pump and heater) must be connected to a separate 120 VAC 15 AMP circuit.
3. GFCI - A Ground-Fault Circuit-Interrupter (GFCI) must be installed in the circuits which bring power to the whirlpool; do
not omit. To test the GFCI, push the test button. The GFCI should interrupt power. Push the reset button. Power should
be restored. If the GFCI fails to operate in this manner, there is a ground current flowing, indicating the possibility of
an electric shock. Do not use this unit. Disconnect the unit and have the problem corrected by a licensed electrician
before using.
4. Grounding - Motors have a three prong electrical plug. A ground should be run from J-box receptacle to electrical
house panel per code.
5. Bonding - A pressure wire connector is provided on the exterior of some motors and heaters (optional) within this
unit to permit connection of a No. 8 AWG solid copper bonding conductor between all electrical equipment, as
needed to comply with local requirements. Double plastic insulated motors have no pressure wire connector as it
is not needed.
6. Wall Switch - A remote wall switch is required by many state codes. It must not be within 5 ft (1.5m) reach of a
bather while standing in the tub and it must be mounted at a height to be out of the reach of small children. Not
further than 10 ft (3.0m) away.
7. Integral On/Off Switch - For an Aquatic Whirlpool supplied with a motor that has an integral on/off switch - Make
certain the air tube that is connected to the motor is also connected to the on/off button nipple under the deck in
order for the system to function. Air tube must not be kinked, compressed, or slit.
8. Inline Heater (optional) - Units equipped with an inline heater have their own electrical pigtail and three prong plug
to be plugged into its own dedicated circuit.
INSTALLATION INSTRUCTIONS