Full Product Manual

Aquatic 21
Millennium Owner's Manual & Installation Guide
INSTALLATION INSTRUCTIONS
DUAL SIDED REMOTE CONTROL INSTALLATION
Receiver Module Installation
the Receiver Module and remote may be used in conjunction with the supplied keypad or
without. The two receiver modules must be installed under the bathtub rim.
IMPORTANT: In order to obtain the best reception possible, we recommend not to install
the receiver module next to the faucets or metal piping. Location of the receiver module
must be easily accessible from the outside of the bathtub for maintenance.
Remote control and keypad used to activate the systems
1. Plug in the cables as shown on the drawing.
2. Once everything is connected, the remote control
is ready for synchronization.
Remote control only, to activate the systems
1. Plug in the cables as shown on the drawing.
2. Once everything is connected, the remote control is
ready for synchronization.
Synchronization
1. Once the system has been connected, each side of the remote control
must be synchronized with its own receiver module.
2. Switch off the main breaker or unplug the two systems and switch it
on again one at a time.
3. From this moment, you have 15 seconds to proceed with
the synchronization.
4. Press simultaneously on the button 2 and button 3 of the remote for 4 seconds on the side you would like to program.
5. Keeping the first system plugged in, plug in the second system and follow steps 2 – 4.
6. The remote control is now synchronized on both sides and ready to use. Now you should be able to control the two
systems independently.
7. If the synchronization is not
successful the first time, you
should resynchronize, starting
from step 2.
Modules and keypads
are factory installed
Figure 8
RECEIVER
MODULES
DUAL SIDED
REMOTE CONTROL
BLOWER OR
L
ECTRONIC CONTROL
BLOWER OR
ELECTRONIC CONTROL
SYSTEM
#
1 SYSTEM #2
RECEIVER
MODULES
BLOWER OR
ELECTRONIC CONTROL
BLOWER OR
ELECTRONIC CONTROL
SYSTEM #1 SYSTEM #2
DUAL SIDED
REMOTE CONTROL
RECEIVER
MODULES
Figure 7A
Figure 7B