Installation Sheet
16 Aquatic
1. Pressing the On/Off button will
turn the blower on in “constant mode.” Once the blower is on,
pressing a second time will turn the blower off. The light indicator
will illuminate when the system is on. The blower and the blower
heater will automatically shut off after a 20-minute period.
2. Pressing the Mode button alternates the
blower modes of operation from constant mode to wave mode and
then to pulse mode.
• Constant Mode: Consists of a constant blower level with no change. The light indicator will also follow the
blower intensity set by the user.
• Wave Mode: Consists of a gradual change of blower level to generate a gentle massage effect. The light
indicator will also follow the blower intensity.
• Pulse Mode: Consists of an instant change of the blower level to generate a massage effect. The light indicator
will also pulse as the blower does.
1. Pressing the “On/Off” button will turn the jet sequencer on. The system will then
perform an indicator light test and open all valves. Pressing the “On/Off” button a second time will turn the jet
sequencer off. A built-in timer automatically turns the jet sequencer off after 2 hours, unless manually deactivated
first. Pump must be turned on for the jet sequencer to be effective (see “Infinity On/Off with Heater Control”
above.)
2. Press the “Sequences” button to select
one of the 7 preprogrammed massage sequences. Note: only
the first 6 sequences have corresponding indicator lights. The
remaining sequences do not have indicator lights. A preview of the
massage is displayed for 5 seconds after selecting a sequence.
3. Press the “Speeds” button to change the time
interval between each step of the selected massage sequence.
Speed 1: 15 Seconds between each step.
Speed 2: 10 Seconds between each step.
Speed 3: 5 Seconds between each step.
4. Press the “Pause” button to interrupt a massage sequence and prolong the action of a jet set for a
combination of sets. Pressing a second time will resume the massage sequence. The “Pause” indicator light
will be on in “Pause” mode.
• Automatic purge: Thirty minutes after the jet sequencer has shut off, the solenoids will open and close to drain
any water from the pipes.