Installation Sheet
22 Aquatic
Before tub is used, the whirlpool system should be cleaned and disinfected. Remove all debris and clean tub before
putting whirlpool into service. DO NOT USE ABRASIVE CLEANERS ON THE ACRYLIC FINISH. Use a non-abrasive
detergent and rinse well after cleaning.
• Fill the tub with HOT water to a level 2” above the highest jet.
• Add 2 teaspoons of low-sudsing automatic dishwashing detergent and no more than 4 ounces of household
bleach to the water.
• Operate whirlpool for 10 minutes. Drain. To effectively clean both the whirlpool and air bath system, you
must operate them both. (See sections entitled “Infinity On/Off with Heater Control” [Diagram 6A] and “Infinity
Air Bath Control” [Diagram 6C], pages15-16).
• Refill with cold water and operate whirlpool for 5 minutes. Drain.
To remove accumulations of bath residue from the whirlpool system, we recommend that you purge it at least twice
a month, or more depending on usage. To do this, follow this simple procedure. Fill the bath with hot water (not
exceeding 140
o
F). Add to the hot water, 4 (6) tablespoons of low foaming detergent such as liquid Cascade or
Calgonite and 24 (48) oz. of liquid household bleach, such as Clorox [use lesser amounts shown for 5-foot bathtubs,
greater amounts in parentheses for larger bathtubs]. Run the bath for 5 to 10 minutes. Drain the bath completely
and refill with cold water only. Run the whirlpool for 5 to 10 minutes, then drain the bath completely. Depending
on the usage and/or the content of the local water supply, more frequent purging may be necessary.
Before tub is used, your air bath and plumbing system should be flushed. Close the drain. Fill bath with hot water
to at least six inches above air injector holes. Add 2 teaspoons of low sudsing automatic dishwashing detergent
and no more than 4 ounces of bleach to the water. use bleach or other chlorinated cleansers on metal trim
surrounding control panels. Turn blower on for approximately two minutes to mix cleaner with water. Shut blower
down and allow cleaner to soak in the bath for approximately two hours. Turn ON air bath and run for approximately
five minutes. Turn air bath unit OFF and drain tub. Aquatic recommends the above cleaning process on your air
bath system once a month.
If you want to use any kind of bath additive, use only a small amount of low-foaming powder or crystal substance;
the whirlpool action intensifies the foaming properties of soaps.
The use of certain bubble baths and bath additives may increase the level of accumulations of bath residue in the
whirlpool system. If excess accumulations persist, you should discontinue use of these products.
If you have followed the monthly purging instructions and still have an excess accumulation of bath residue and
desire an alternative cleaning mechanism, we recommend manufactured by Stearns
Packaging Corporation to rectify this condition. This may be obtained by calling Aquatic, at (800) 555-5324. It is
recommended that you follow the instructions provided by the manufacturer with the product. Repeated use may
be necessary. does not replace the necessity to purge your whirlpool system at
least twice a month with a low foaming detergent and bleach.