Installation Sheet
6 Aquatic
3. Place the tub in an area where it may be drained after testing.
4. Fill the tub with hot water (approximately 100
0
F) to the overflow and allow to stand for a few minutes.
Carefully inspect all fittings and connections for leaks.
5. Plug in pump and blower cords and run pump for 10 minutes.
6. With the pump running, turn on the blower. Check all functions.
7. Inspect the tub completely. Any defect must be reported to Aquatic prior to installation in order to have it
covered by warranty.
8. Check to ensure that your installation will conform to all applicable codes and secure necessary permits.
All electrical and plumbing connections should be made by qualified electricians and plumbers.
Whirlpool pump and piping are factory assembled. Relocation of pump or other modifications could
adversely affect the performance and safe operation of this whirlpool. Aquatic shall not be liable under its warranty
or otherwise for personal injury or damage caused by any such unauthorized modification.
Aquatic has engineered their whirlpool baths from base to lip to ensure quality,
value, functional design, and maximum bathing comfort. However, installation is accountable for as much as 50%
of a tub’s operating quietness. Please ensure the following:
• The floor structure is adequate to support the installation.
• For quieter operation and heat retention conservation, the walls surrounding the whirlpool may be insulated.
• Insulate the tub surround. Do not allow any insulation to come within 3 feet of the pump. The area around the
pump must be clean and free of any foreign matter.
• Leave 1/8” to 3/16” gap between tub lip and surround.