Installation Sheet
Aquatic 9
A. Install the whirlpool bath unit per the instructions provided in this manual.
A ledger board be provided under the
bath rim as indicated in the installation instructions. Take care to ensure tub is not hanging from the ledger
boards, as this will void your warranty.
B. Use nails or screws to secure the flange into the studs around the bath.
C. Install water resistant drywall against the tile flange and flush to the top of the whirlpool deck. Install the tile or
other finishing materials. Apply a second bead of silicone between the first course of tile and the bath deck.
1. After securing tub in place, normal waste and overflow and valves (3/4” valves are recommended) are installed
per normal plumbing procedures, in accordance with all state and local standards.
2. Install standard 1-1/2” trap to drain and overflow. Before proceeding, make a final operational check by filling
tub with water to overflow and operate pump for 5 minutes. Check for leaks carefully both while pump is running
and has been turned off. Allow water to stand in tub for at least 30 minutes before draining.
3. All Infinity Series models are equipped with an integral Fast Fill Waterfall Spout. Purchasing a spout is unneces-
sary, however, hot and cold water valves are needed. Valves can be mounted where you choose, however, if
installation is to be on the tub deck, check the back side of the tub for adequate space for connection to water
lines before drilling or cutting tub.