AQ-MP-5BT-H - WATERPROOF MEDIA PLAYER for Bluetooth & MP3 devices USER / INSTALLATION MANUAL Replaces Factory Radio on Harley-Davidson® Motorcycles (Models 1998-2013) USB charging PLEASE READ THIS INSTRUCTION MANUAL BEFORE INSTALLATION AND OPERATION
Table of Contents Media Player AQ-MP-5BT-H 1 Getting Started......................................................................................................................... 3 1.1 Contents.............................................................................................................................3 1.2 Connections........................................................................................................................3 1.3 Wiring Diagram................................
Getting Started Media Player AQ-MP-5BT-H 1.1 Contents • AQ-MP-5BT-H Digital Media Player • Four-pin Speaker Wiring Harness • Owner’s Manual 1.2 Connections (see also ‘1.3 Wiring Diagram’) 1. 23-pin Harley-Davidson® Standard Harness Connection The 23-pin harness supplies power and ground connections to the Media Player and two speaker channel output connections from the Media Player. 2. FM/AM Radio Antenna Jack Allows connection of FM/AM radio antenna.
Getting Started Media Player AQ-MP-5BT-H 1.3 Wiring Diagram 5 1 4 3 6 2 No lower than a 2 Ohm load should be used or damage may occur to the Media Player. Make sure the polarity of speakers are connected correctly. www.aquaticav.
Getting Started Media Player AQ-MP-5BT-H 1.4. Mounting Precautions Please observe the following precautions: 1. Install the unit where it does not interfere with driving. 2. Check clearances on both sides of a planned installation before drilling any holes or installing any screws. 3. When routing RCA cables, keep them away from power cables and speaker wires. A common source of noise in the audio system is the motorcycle ignition system.
Getting Started Media Player AQ-MP-5BT-H 1.6 Installing the Media Player if an existing factory stereo is already installed If replacing an existing Harley-Davidson® factory stereo use the existing Harley-Davidson® factory side mounting brackets and hardware to mount the Media Player. 1. Unplug the 23-pin harness and FM/AM radio antenna from the factory stereo. 2. Remove the factory stereo and replace with the AQ-MP-5BT-H Media Player using the existing factory mounting hardware. 3.
Getting Started Media Player AQ-MP-5BT-H 1.8 Handle Bar Controls Audio switch (left hand side) Mode switch (right hand side) The AQ-MP-5BT-H is a plug and play solution for 1998-2013 Harley-Davidson® Motorcycles. Plug the standard Harley-Davidson® 23-pin connector in to the back of the AQ-MP-5BT-H and your speakers and hand controls will work the same as the standard factory install (some HarleyDavidson® models may require additional steps). Some stock Harley-Davidson® features e.g.
Location of Controls Media Player AQ-MP-5BT-H 2.1 Media Player Controls 1 2 11 3 10 4 9 12 3 5 8 4. Mode button 1. Front face release 2. Preset station 5. Band button 3. Fast Rewind/Forward 6. LCD screen Button Rotary Select Knob Mode Rotary Knob Clockwise Rotary Knob Counter Clockwise Fast Forward Fast Rewind Play/Pause Band XBS DSP/Dimmer ESC/Info Preset Audio/Menu 6 7 7. Audio/System menu 8. XBS function 9.
Listening to Devices Media Player AQ-MP-5BT-H 3.1 Listening via Bluetooth 3.1.1 Pair with Bluetooth Device 1. Switch on your Bluetooth device. 2. Select ‘AQUATIC AV’ from the list of available devices to pair (no password is needed). 3. A Bluetooth logo will illumiate on the Media Player LCD to verify Bluetooth is activated. Only one Bluetooth device can be paired with the Media Player at any time. 3.1.2 Listening via Bluetooth Device 1. Bluetooth mode will be activated once a Bluetooth device is linked.
Listening to FM/AM Radio Media Player AQ-MP-5BT-H 4.1 Enter FM/AM Radio Mode 1. Press MODE on the unit keypad to switch to FM/AM radio mode. 4.2 Scan or Navigate FM/AM Radio Channels 1. Press FAST REWIND/FAST FORWARD to seek another station. 2. Press and hold either FAST REWIND/FAST FORWARD for manual tuning back or forward. 4.3 Saving Radio Channel to Memory 1. Tune to the station you would like to be saved as a preset. 2. Press and hold the ‘Preset’ Button. 3.
Settings Operation Media Player AQ-MP-5BT-H 5.1 Audio Menu From the ‘Audio Menu’ you are able to change the bass, treble, balance, and fader. 1. To enter the ‘Audio Menu’ press the ‘AUDIO/MENU’ button. 2. In the ‘Audio Menu’ press the ‘AUDIO/MENU’ button to scroll through all options. 3. To change the parameters use the rotary knob to adjust settings. Any changes made in the ‘Audio Menu’ are system wide so it will affect all modes. 5.2.
Settings Operation Media Player AQ-MP-5BT-H 5.7 Beep Tone Beep tone plays when any button is pressed, it can be toggled on and off from this selection. 5.8 System Reset Restores all factory settings. www.aquaticav.
Specifications & Dimensions Media Player AQ-MP-5BT-H 6.1 Specifications Media Supported media....................................Bluetooth/MP3/FM/AM Supported media max. dimensions...........107 x 184mm (WxH) Device charging......................................via USB Inputs Auxiliary................................................ 1x 3.5mm stereo Jack socket, 1x stereo pair RCA Outputs Pre-Out..................................................1x stereo pair RCA (2V) Power Output voltage @ 2 Ohm............
Warranty Information Media Player AQ-MP-5BT-H Aquatic AV offers a limited warranty of our products on the following terms: Length of warranty 2 years on audio systems, electronics, speakers, and accessories (receipt required). Coverage This warranty covers only the original purchaser of an Aquatic AV product purchased from an authorized Aquatic AV dealer.
FCC Statement Media Player AQ-MP-5BT-H FCC ID: MADE IN CHINA This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: The equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
Aquatic AV 282 Kinney Drive San Jose, CA 95112, USA E-mail: info@aquaticav.com US & Canada: 1 877 579 2782 International: +1 408 559 1668 Fax: +1 408 559 0125 www.aquaticav.
AQ-MP-5BT-H :$7(53522) 0(',$ 3/$<(5 )25 +$5/(< '$9,'621® 02725&<&/(6 02'(/6 Uses existing HarleyDavidson® mounting location, screws and screw holes. USB charging Plug & Play with existing Harley-Davidson® wiring harness. SPECIFICATIONS Supported Media: DIMENSIONS Bluetooth/MP3/AM/FM 214.4mm 214.4mm Fits devices up to the size of Samsung Galaxy Note Bluetooth, 1x 3.5mm stereo jack, 1x stereo pair RCA Outputs: 1x pair RCA Pre-out (2V) AM/FM Tuner: 18x FM, 12x AM pre-set memory.
