Owner's Manual

1.6 Installing the Media Player if an existing factory stereo is already installed
If replacing an existing Harley-Davidson
®
factory stereo
use the existing Harley-Davidson
®
factory side mounting
brackets and hardware to mount the Media Player.
1. Unplug the 23-pin harness and FM/AM radio antenna
from the factory stereo.
2. Remove the factory stereo and replace with the
AQ-MP-5BT-H Media Player using the existing factory
mounting hardware.
3. Plug the 23-pin harness and FM/AM radio antenna
into the AQ-MP-5BT-H factory stereo.
4. Turn the Media Player on to confirm operation (motorcycle ignition switch must be on) and
once correct operation is achieved turn the motorcycle ignition switch off before proceeding
with the final mounting of the chassis.
4. Ensure that the unit is supported and secured on the sides using the existing 4 factory
screws; failure to do so may allow the unit to move during while riding, causing damage to
the mounting area.
1.7 Connecting Rear Speakers
Rear speakers are usually installed on the following Harley-Davidson
®
Motorcycle models: Electra
Glide Ultra Classic, Road Glide Ultra, Ultra Limited. To continue using these speakers with your
Aquatic AV Media Player follow the instructions below.
1. Locate the Aquatic AV 4-pin pigtail connector (4-pin molex connector with four speaker wires).
The pigtail itself is labelled with Color Code, Function and Description.
2. Locate the stock 35-pin wiring harness that was connected to your OEM radio. This connector
will not be connected to your Aquatic AV head unit. Cut the four matching colored wires from the
back of the 35 pin harness 3” down from the connector.
3. Strip the 4-pin pigtail wires 1/4” exposing bare wires. Strip the 4 wires that you cut from the
35-pin harness 1/4” exposing bare wires.
4. Connect and crimp using crimp caps or solder the connection, cover the soldered wires with
non conductive heat shrink tube.
After following the installation instructions above test your rear speakers for sound. If you do not have output from your
rear speakers make sure to check your rear speaker setting in the settings menu and select rear speakers ‘ON’.
Getting Started Media Player AQ-MP-5BT-H
6www.aquaticav.com/harley