AQ-MP-5BT - WATERPROOF MEDIA PLAYER for Bluetooth & MP3 devices OWNER MANUAL WATERPROOF MEDIA PLAYER USB charging PLEASE READ THIS INSTRUCTION MANUAL BEFORE INSTALLATION AND OPERATION
Table of Contents Media Player AQ-MP-5BT 1 Getting Started......................................................................................................................... 3 1.1 Contents.............................................................................................................................3 1.2 Connections........................................................................................................................3 1.3 12-pin Harness Connection.......................
Getting Started Media Player AQ-MP-5BT 1.1 Contents • • • • • • • • AQ-MP-5BT Digital Media Player Wiring Harness (AQ-UNH-2) Four (4) Stainless Steel Mounting Screws Spare Fuse Mounting Template Mounting Bracket DIN Cage Owner’s Manual 1.2 Connections (see Wiring Diagram 1.4) 1. 12-pin Watertight Harness The 12-pin harness supplies power and ground connections to the Media Player and four (4) speaker channel output connections from the Media Player (see also 1.3 below).
Getting Started Media Player AQ-MP-5BT 1.4 Wiring Diagram 5 4 2 3 1 6 No lower than a 2 Ohm load should be used or damage may occur to the Media Player. Make sure the polarity of speakers are connected correctly. www.aquaticav.
Getting Started Media Player AQ-MP-5BT 1.5. Mounting Precautions 1. A mounting template is included. Aquatic AV recommends using the ‘measure twice, cut once’ method! 2. Once the mounting hole is complete, make sure the outside surface is clean and clear of debris. The Media Player has an external water/dust proof gasket, but this requires a clean and flat surface for best performance. 3. The Media Player has four (4) front screws. Drive the screws using a screw driver.
Getting Started Media Player AQ-MP-5BT 1.6 Mounting the Media Player The AQ-MP-5BT is designed for a multi-environment application. For an easy system setup, mount the Media Player so the front controls will be easily accessible. In addition, observe the following precautions: 1. Check clearances on both sides of a planned installation before drilling any holes or installing any screws. 2. When routing RCA cables, keep them away from power cables and output speaker wires. 3.
Getting Started Media Player AQ-MP-5BT 1.6.2 Slide mounting brackets into position and tighten center bolts. Remove mounting bracket handles by bending backing brackets handles until they break off. 1.6.3 Slide Media Player into mounting sleeve. Secure Media Player using supplied hardware and mounting strap. www.aquaticav.
Getting Started Media Player AQ-MP-5BT 1.7 Power On The AQ-MP-5BT requires +12V DC to both the red and yellow wires. When both of these wires have power the AQ-MP-5BT is always powered on. Ground is connected to the black wire. Once all connections are made press the rotary knob and the stereo will turn ON. In a spa application this requires the red and yellow wires to be jumped together and then connected to the +12VDC output of the power source.
Location of Controls Media Player AQ-MP-5BT 2.1 Media Player Controls 1 2 11 3 10 4 9 3 5 8 4. Mode button 1. Front face release 2. Preset station 5. Band button 3. Fast Rewind/Forward 6. LCD screen Button Rotary Knob 6 7 7. Audio/System menu 8. XBS function 9. Play/Pause 10. ESC/Information 11.
Listening to Devices Media Player AQ-MP-5BT 3.1 Listening via Bluetooth 3.1.1 Pair with Bluetooth Device 1. Switch on your Bluetooth device. 2. Select ‘AQUATIC AV’ from the list of available devices to pair (no password is needed). 3. A Bluetooth logo will illumiate on the Media Player LCD to verify Bluetooth is activated. Only one Bluetooth device can be paired with the Media Player at any time. 3.1.2 Listening via Bluetooth Device 1. Bluetooth mode will be activated once a Bluetooth device is linked.
Listening to FM Radio Media Player AQ-MP-5BT 4.1 Enter FM Radio Mode 1. Press MODE on the unit keypad to switch to FM radio mode. If this is the first time you listen to FM radio, the default frequency will be 87.5MHz, as shown on the display. FM radio is only available when you using the FM Radio mode. 4.2 Scan or Navigate FM Radio Channels 1. Press FAST REWIND/FAST FORWARD to seek another station. 2. Press and hold either FAST REWIND/FAST FORWARD for manual tuning back or forward. 4.
Settings Operation Media Player AQ-MP-5BT 5.1 Audio Menu From the ‘Audio Menu’ you are able to change the bass, treble, balance, and fader. 1. To enter the ‘Audio Menu’ press the ‘AUDIO/MENU’ button. 2. In the ‘Audio Menu’ press the ‘AUDIO/MENU’ button to scroll through all options. 3. To change the parameters use the rotary knob to adjust settings. Any changes made in the ‘Audio Menu’ are system wide so it will affect all modes. 5.2.
Settings Operation Media Player AQ-MP-5BT 5.7 Beep Tone Beep tone plays when any button is pressed, it can be toggled on and off from this selection. 5.8 System Reset Restores all factory settings. www.aquaticav.
Specifications & Dimensions Media Player AQ-MP-5BT 6.1 Specifications Media Supported media....................................Bluetooth/MP3/FM/AM Supported media max. dimensions...........107 x 184mm (WxH) Device charging......................................via USB Inputs Auxiliary................................................ 1x 3.5mm stereo Jack socket, 1x stereo pair RCA Outputs Pre-Out..................................................1x stereo pair RCA (2V) Power Output voltage @ 2 Ohm..............
Warranty Information Media Player AQ-MP-5BT Aquatic AV offers a limited warranty of our products on the following terms: Length of warranty 2 years on audio systems, electronics, speakers, and accessories (receipt required). Coverage This warranty covers only the original purchaser of an Aquatic AV product purchased from an authorized Aquatic AV dealer.
FCC Statement Media Player AQ-MP-5BT FCC ID: MADE IN CHINA This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: The equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
Aquatic AV 282 Kinney Drive San Jose, CA 95112, USA E-mail: info@aquaticav.com US & Canada: 1 877 579 2782 International: +1 408 559 1668 Fax: +1 408 559 0125 www.aquaticav.
AQ-MP-5BT :$7(53522) 0(',$ 3/$<(5 USB charging SPECIFICATIONS Supported Media: DIMENSIONS Bluetooth/MP3/AM/FM Fits devices up to the size of Samsung Galaxy Note and iPhone 6 Plus. Display: Dot Matrix LCD Detachable Faceplate: Yes Inputs: Bluetooth, 1x 3.5mm stereo jack, 1x stereo pair RCA Outputs: 1x pair RCA Pre-out (2V) AM/FM Tuner: 18x FM, 12x AM pre-set memory. US/Euro frequencies Power (max): 4x 45W (4 Ohms), 4x 72W (2 Ohms) $PSOL¿HU 7\SH Class A/B (2 Ohm stable) Output Voltage: 9.
