Owner's Manual

products with a watertight reputation
AQ-RF-6UBT
WATERPROOF
REMOTE
CONTROL
Contents
Please
check
first
that
the package contains
all
of
the items
below.
If
something is missing,
contact the store where
you
purchased the product.
•
Remote
Control
RF
Handset (AQ-RF-6UBT-T)
•
RF
Receiver (AQ-RF-6UBT-R)
•
Charging
Cable
Charging
the
Remote
Control
The remote has a built-in Polymer
Lithium rechargeable
battery and comes with a charging
cable.
Connect one end of the charging cable
to the charging connection
on
remote control
and connect
the USB end
of
the charging
cable
to any USB charger
(5V
DC)
for charging.
Make sure the remote has been charged before
used
.
Synchronizing
the
Remote
Control
The remote
should already
be
paired from the factory,
but
if
you
need
to
synchronize
the
remote,
follow
the steps below.
1.
Connect the receiver
dongle
to
the
female Dl
N connector of the Aquatic
AV
stereo before the
stereo is powered ON.
2. Turn the power
to
the stereo
ON
and
hold
the
remote
control close
to
the stereo.
3.
Press
and
hold MODE
on
remote control until
the
LCD
shows
"Pairing in
Progress" and then
release
the
button.
4.
The remote's
LCD
should display
"Paired"
within
2 seconds to verify pairing has been suc-
cessful.
If
it
fails
to
pair,
the
LCD
will display "Retry again".
If
this
happens, wait 5 seconds and
repeat the above procedures.
n
If
the
pairing
process is
not
successful,
try
again to
put
your remote close to the remote receiver.
0
Depending on the frequency
of
usage, the remote may drain its battery. Please
charge the remote before use.
If
the LCD
shows nothing, the battery has been drained
and
will
need charging.
Aquatic
AV,
282
Kinney
Drive,
San
Jose,
CA
95112
,
USA
.
info@aquaticav
.
com
-
US
&
Canada
: 1
877
579
2782
-In!:
+
1
408
559
1668
www.aquaticav.com