User's Manual

External
Trigger +12VDC (7)
DC Ground (10)
LR-(2)
+12VDC(1)
LR+(3)
LF-(5)
LF+(6)
RF-(8)
RF+(9)
Not connected (4)
RR-(11)
RR+(12)
FUSE BOX
Left Rear Speaker
+
-
Left Front Speaker
+
-
+
-
+
-
Right Front Speaker
Right Rear Speaker
Please put a
fuse into the box
3
(Red color)
(Blue color)
(Green/strip)
(Green color)
(White/strip)
(White color)
(Gray/strip)
(Gray color)
(Purple color)
(Purple/strip)
(Black color)
12 Pin Harness Cable Connection
GETTING STARTED
Aquatic AV recommends the use of a optional "plug and play" connector for best
performance (AQ-UNH-1). This connector is not included.
For detailed information, please call the re-seller. If you choose
not to use the "plug and play" option, you can use the wiring schematic below.
All open wire connections should be soldered, and protected against
Water/Dust for best long term performance.
4 ohm
4 ohm
4 ohm
4 ohm
Must use 4 ohm load or
damage may occur to the AQ-DM-2Bx
(Yellow color)
Once the mounting hole is complete, make sure
the outside surface is clear of debris. The
AQ-DM-4 has an external water/dust proof UBT
gasket, but it needs a clean surface for best
performance.
2.
Mounting templates are included. Aquatic AV
recommends to utilize the "measure twice, cut
once" Method.
1.
Review all outside surfaces of the AQ-DM-4UBT to insure proper water/dust U
seal. This is important for the long term environmental protection
performance for iPod or MP3 devices.
4.
The AQ-DM-4 has Six (6) front screwsUBT
Drive the pcs of screws with a screw driver. 6
During final mounting, apply equal pressure to
all points for best water/dust outer seal performance.
3.
Mounting the Unit
Make sure the polarity of speakers
are connected correctly.
AQ-DM-4
MODEL: AQ-DM-4UBT
FILE NAME: IB-DM-4UBT_manual_103012