User's Manual

USER MANAUL

AQ-SWA8-6BT-2

Harness Connections

The ACC will need a 12V constant power to turn the unit ON. The yellow and the black will be

connected to a 12V dc supply.

Locations of controls

1. Use AUX level selector to set the AUX input.

2. Connect your player to the Subwoofer with Bluetooth or using the AUX input.

3. A 8-pin DIN connector is used to connected to a remote dongle (not included) so that you

can control the subwoofer remotely.

4. A SMA connector is used to connect to an Antenna for extended range

5. The USB cable provide a 5V voltage @2.1A

Connecting to Bluetooth

The default mode of SWA8-6BT is Bluetooth mode. If there is no device connected to the Bluetooth,

you can use the AUX input. Bluetooth will always be at higher priority than AUX input. AUX will only

be playing music if no bluetooth is playing.

PAGE 1
USER MANAUL AQ-SWA8-6BT-2 Harness Connections The ACC will need a 12V constant power to turn the unit ON. The yellow and the black will be connected to a 12V dc supply. Locations of controls 1. Use AUX level selector to set the AUX input. 2. Connect your player to the Subwoofer with Bluetooth or using the AUX input. 3. A 8-pin DIN connector is used to connected to a remote dongle (not included) so that you can control the subwoofer remotely. 4.
PAGE 2
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.