Users Manual

RF Wireless Remote
Instructions
RGB LED Controller
19 Dynamic Modes
20 Static Colors
Speed Adjustable
Brightness Adjustable
Ultra Slim Design
Card Type Remote
Easy Remote Pairing
Direct Color Select
This unit accepts DC 5V to 24V power supply . The inner pole
polarity is positive and sleeve is negative . Please select proper
power supply according to the LED application.
This unit support common anode connection LED products.
The mark“”indicates the common connection node. The
peak output current is 4A per channel, please reduce load if
main unit is overheating.
11.Demo Mode
1.Powe r Supp ly
2.LED Output
Press this key will switch to Demo mode. At demo mode, it
will loop play 9 dynamic modes, each mode repeat 3 times.
lnstalling
7/8 .Br igh tne ss Adj ust
Adjust static color brightness. Press Bright+ to increase
brightness and press Bright- to decrease. Unit will switch to
static color mode lf press this key at dynamic mode.
3.Remote Controller
Please pull out the insulate part before using . The RF wireless
remote signal can pass through barrier , so it’s not necessary
to aim at the main unit when operate . For proper receiving
remote signal , do not install the main unit in closed metal parts.
The remote battery is 3V CR2025 type , please only replace
with same type battery.
LED CONTROLLER
With RF Remote Control
:3*4APeak Output Current
Common
Node
1
2
Press this key to turn on unit or switch to standby mode. Unit will
turn on and restore to previous status at powering on moment.
Switch to dynamic mode from static color mode, or switch
between dynamic modes.
Adjust dynamic playing speed. Press Speed+ to increase speed
and press Speed- to decrease speed. Unit will switch to dynamic
mode lf press this key at static color mode.
Switch to static color mode from dynamic mode, or switch
between different static colors.
1.Tu rn on /Stand by
2/9.Dynamic Modes Adjust
3/10.Dynamic Seed Adjust
4/5.Static Color Adjust
6.Direct Color S elect
Shortcut key to static colors. When press the specific color
key.LED will play the same static color. The direct colors are
included in‘COLOR+’and‘COLOR-’operation.
Very Smooth Effects
Demo Mode
Specification
Dynamic Mode
Static Color
Brightne ss Gra de
Speed Gra de
Working Volta ge
Output Current
Remote Frepue ncy
Remote Distance
19 modes
20 colors
5 levels
10 levels
DC 5~24V
3-way, peak 4A pe r channe l
433.92MHz
15m at open area
PWM Grade
256 levels
Demo mode
Yes
70.00 mm
CAUTION !Do no t short c ircuit th e LED out put ,thi s may
lead to permanent damage!
Functions
MODE
+
SPEED
+
SPEED
-
DEMO
MODE
-
COLOR
+
COLOR
-
BRIGHT
+
BRIGHT
-
RF Wireles s
1
2
3
4
5
11
10
8
7
9
6
CS9016