THE ULTIMATE COOLING CHAIR PRODUCT MANUAL
Contents Safety messages 3 Specifications and contents 4 Assembly instructions 5 Operation instructions 9 Warranty statement 11 Troubleshooting 12 IMPORTANT Please save this product manual for future reference. Additional copies are available at www.aquonchair.
Warning Thoroughly read and understand the information in this product manual before attempting assembly and before using this product. Assemble only according to instructions. Keep assembly area clean and well lit. Keep bystanders out of area during assembly. Do not use this product outside the weight requirements specified in this product manual. Inspect the product regularly for loose or missing screws, cracks, general instability or excessive wear.
Congratulations on your purchase of the AQUON The Ultimate Cooling Chair! The AQUON Ultimate Cooling Chair is an office chair that actively cools the occupant. It is intended to provide comfortable cooled seating with adjustable support for people who do a combination of physical labor and desk work, in an office environment or at home. For optimal effectiveness the AQUON should be used with lightweight clothing.
Assembly Instructions Read the entire section before beginning assembly. Neither the manufacturer nor distributor makes any representation or warranty of any kind to the buyer that he or she is qualified to make any repairs to the product, or that he or she is qualified to replace any part of the product.
Step 1 Press the five castors(1) in to the base(2). Place the base(2) on the floor with the castors(1) down. Insert the seat post(3) in to the base(2) with the wide end down.
Step 2 Place the seat(4) mesh down on a stool or short ladder. Attach the left and right arm rests(6) (7) with the six 30mm screws(8) and 16mm washers(9) using the hex tool. The two 18mm spacers(12) are pre-glued in place on the back rest. These spacers can be removed to increase the rack of the back rest. Slide the back rest(5) in to the metal bracket on the seat(4) until all three holes line up. Install the 20mm screws(10) and washers(11) through the metal bracket in to the back rest(5) with half a turn.
Step 3 Join the bottom half from step 1 to the top half from step 2 by sliding the top of the seat post in the seat.
Operation Instructions After assembly, fill the water bottle with distilled water. Use the water bottle to fill the chairs water reservoir by injecting water in to the hole on the top of the rubber bulb.
After the reservoir is full, using your thumb to cover the hole on the top of the rubber bulb. With a downward motion pump the water down in to the sealed chamber in the chair back. Do not pump air in to the sealed chamber. The chair typically needs one pump every couple of days to keep the sealed chamber full. When the chair arrives the sealed chamber may be very low and require two or more reservoirs of water to be added. Try to pump two reservoirs of water in to the sealed chamber.
Warranty Statement The limited warranty for the AQUON chair remains in force for two (2) years and is valid from the date of purchase. The original purchase receipt is required as proof of purchase.
Trouble Shooting Fan does not spin – Check the light on the power supply. If the light is off, check the power cord to the wall outlet. If the light is on, check the 5.5mm plug in to the pigtail connector on the back of the chair. The back rest is not getting cold – If the fan is spinning then the problem is the sealed chamber does not have enough water. Pump two full reservoirs of water and let the chair run for 5 minutes. If the back rest is still not cool, repeat until cool.