AR610 Blue Clean Place Stamp Here Use • Maintenance Manual Warning: A.R. North America Attn: Pressure Washer Warranty Department 140 - 81st Avenue NE Fridley, MN 55432 This manual must be read before installation or use of the unit.
Pressure Washer Limited Warranty This product is under warranty to the original retail consumer against defects in material and workmanship for a period of 1 (one) year and is a complete “bumper to bumper” warranty including the spray gun, the high-pressure hose and all accessories from the date of purchase. The warranty is not transferable or assignable. This warranty covers replacement parts.
Notes 1. Introduction The high pressure power-jet cleaner you have purchased is a technologically advanced product designed by one of the leading European manufactures of high-pressure pumps. To obtain the best performance from your unit, read this booklet carefully and follow the instructions each time you use the cleaner. We congratulate you on your choice and wish you successful operation. * Read and understand these instructions before operating the cleaner.
2.1.11 2.1.12 2.1.13 2.1.14 2.2 2.2.1 2.2.2 Do not tamper with or alter the calibration of the safety valve. EXPLOSION HAZARD. DO NOT alter the original diameter of the spray head nozzle. OVER PRESSURIZATION MAY OCCURE. DO NOT leave the cleaner unattended. ACCIDENT HAZARD. DO NOT move the cleaner by pulling on the electrical cable. SHORT CIRCUIT HAZARD. Safety “MUSTS” All electrical circuits MUST BE PROTECTED against the water jet. SHORT CIRCUIT HAZARD.
AR610 Always use two hands when operating a pressure washer. This will assure complete control of the equipment. Always test the GFCI plug prior to using the cleaner. Never test the pressure of the cleaner against any part of the body. Use the trigger lock whenever the spray gun is not being used for cleaning. Always seek emergency medical care immediately if any fluid penetrates the skin. A cut may be deeper and more serious than it appears. 3. General Rules 3.1.
3.1.11 Use the cleaner only with accessories and replacement parts authorized by the manufacturer. The use of original accessories and replacement parts will ensure safe, trouble-free operation. The cleaner must be used standing on a secure, stable surface, positioned as shown. The pump does not operate at the prescribed pressure. Sudden changes in pressure. Excess noise. Problems and Remedies Water leakages. Problem 3.1.10 Oil leaks. Motor does not start.
6.3 Long periods of non-use may lead to the formation of lime scale deposits. Working through the hole on the rear, RELEASE the motor using a screwdriver (for models with this feature). Then remove the screwdriver and proceed with the restart operations. - Except for the Extreme - 6.4 Clean the nozzle with the tool provided. Remove the lance from the gun; remove any dirt from the nozzle hole and rinse. 4.3 Connect the high-pressure hose to the water (OUTLET) on the cleaner. 4.
5.3 5.3.1 TSS Models: Pull the spray gun trigger; push the switch start the motor. to When re-starting the motor, always keep the spray gun trigger compressed. In TSS models, with automatic delivery flow cut-off: when the trigger is released, the dynamic pressure automatically cuts out the motor. When the trigger is compressed the pressure drop automatically starting the motor and the pressure is restored with a very slight delay.
