Use and Care Manual

En - 12
outlet. Turn off the water supply. Pull the trigger on the spray
gun 2-3 times to drain out the excess water and to release
any remaining water pressure. Disconnect the garden hose
adapter from the water inlet. Do not allow the power washer
to run with no water owing through it.
• The GHA should be stored in the accessory holder when your
unit is not in use to prevent loss or damage (Fig.22).
• Remove high pressure hose from spray gun (Fig.23) and
unscrew the other end of the high pressure hose from the
power washer (Fig.24).
• Remove lance or detergent bottle from the gun and place in
the accessory holder. Place the gun in the accessory holder
in one of the slots. Lances are pressed into and stored in
the half circle notches. Make sure to discard any remaining
detergent from the bottle. Flush the bottle and nozzle head
with fresh water to prevent clogging.
• Wrap the power cord around the accessory holder using the
extension tabs at the 3:00 & 9:00 position and the L-shaped
power cord holder/tab located at the 6:00 position (Fig.25).
• DO NOT store the power washer where it is exposed to
freezing temperatures unless you use Pump Saver. It is
recommended that you use Pump Saver for storing in freezing
temperatures. Freezing will damage the pump unless Pump
Saver is added to the power washer. If not using or if storing
your power washer for more than one month, run Pump Saver
through it. See the section on Pump Saver for more informa-
tion.
pump Saver
Pump Saver is a product that protects and prolongs the life of the
pump. This will keep the internal parts of the pump lubricated and
protected from freezing while being stored in ALL climates. It also
assists with protection from internal corrosion. The Blue Clean part #
is: PW64511 (16oz. bottle).
Pump Saver Instructions
Follow the previous storage instructions for your power washer. To
prevent staining, protect the surface under the power washer from
any excess uid. Wear eye protection when using this product.
1. Turn off your power washer.
2. Disconnect all hoses.
3. Shake the bottle well before connecting to the power washer.
4. Screw the dispensing valve on the bottle of the Pump Saver
into the water inlet on your power washer.
5. Turn the valve on the bottle to the open position.
6. Turn the power washer on. Turn the power washer off as soon
as the Pump Saver uid begins to exit the water outlet.
7. Turn the valve on the bottle to the off position and remove the
Pump Saver bottle and valve assembly from the power washer.
Fig. 23
Fig. 24
High Pressure Hose
Pump
GHA
Fig. 22
Fig. 25