Full Product Manual

15
OPERATING INSTRUCTIONS
Storage
When your pressure washing session has been
completed, turn off the power switch. Unplug the
power cord from the outlet. Turn off the water supply.
Pull the trigger on the spray gun 2 - 3 times to drain
out the excess water and to release any remaining
water pressure. Do not allow the power washer to run
with no water owing through it.
Remove detergent tank and clean completely.
Residual chemical will stick to the container and can
cause the detergent injector to clog and not function
properly.
Remove high pressure hose from spray gun and
unscrew the other end of the high pressure hose from
the power washer.
Remove lance from the gun. Place the gun in
the holder on the side. Make sure to discard any
remaining detergent from the tank. Flush the tank
and nozzle head with fresh water to prevent clogging.
Hook the power cord around the L-shaped tab on the
top of the machine.
The pressure hose is stored on the hose hook located
on the back of the handle.
DO NOT store the power washer where it is exposed
to freezing temperatures unless you use an
antifreeze designed for pumps. It is recommended
that you use this antifreeze (not included) for storing
in freezing temperatures. Freezing will damage the
pump unless this is added to the power washer. If not
using or if storing your power washer for more than
one month, it is also recommended that an antifreeze
is used to protect the pump.
CARE AND MAINTENANCE
OPERATING INSTRUCTIONSVERPUMP SAVER
Pump Saver is a product that protects and prolongs
the life of the pump.This will keep the internal parts
of the pump lubricated and protected from freezing
while being stored in ALL climates.It also assists with
protection from internal corrosion.The AR Blue Clean
part #is: PW64511(16oz. bottle).Order online at
www.arblueclean.com
Pump Saver Instructions
Follow the previous storage instructions for your power
To prevent staining, protect the surface under
the power washer from any excess uid. ear eye
protection when using this product.
Turn unit off and disconnect the gun before adding pump
protector.Unscrew threaded top from bottle to remove
seal and reattach threaded top to bottle.
Remove black cap from bottle.
1) Place top of pump saver bottle onto the garden hose
adapter previously installed to pressure washer inlet.
2) Secure pump saver bottle by turning in a clockwise
direction.
3) Turn power on. Turn the power washer off as soon
as the Pump Savor begins to exit the HP hose.
Note: Instructions on Pump Saver Bottle are generic and
not model specic
2
1
93982_MP_AR 2IN1.indd 15 16/12/19 下午4:17