Use and Care Manual
13
Pump Saver is a product that protects and prolongs
the life of the pump. This will keep the internal parts
of the pump lubricated and protected from freezing
while being stored in ALL climates. It also assists with
protection from internal corrosion. The Blue Clean part #
is: PW64511 (16oz. bottle). Order online at
www.arblueclean.com
Pump Saver Instructions
Follow the previous storage instructions for your power
washer. To prevent staining, protect the surface under
the power washer from any excess uid. Wear eye
protection when using this product.
Turn unit off and disconnect all hoses before adding
pump protector. Unscrew threaded top from bottle to
remove seal and reattach threaded top to bottle.
Remove black cap from bottle.
1) Place top of pump saver bottle onto the garden hose
adapter (G) previously installed to pressure washer
inlet.
2) Secure pump saver bottle by turning in a clockwise
direction
3) Turn power on. Turn the power washer off as soon as
the Pump Saver begins to exit the pump outlet
Note: Instructions on Pump Saver Bottle are generic and
not model specic.
1
2
G
PUMP SAVER
CARE AND MAINTENANCE
Storage
• When your pressure washing session has been
completed, turn off the power switch located on the
front of the power washer. Unplug the power cord
from the outlet. Turn off the water supply. Pull the
trigger on the spray gun 2-3 times to drain out the
excess water and to release any remaining water
pressure. Disconnect the garden hose adapter from
the water inlet. DO NOT allow the power washer to
run with no water owing through it.
• Remove detergent bottle and clean completely.
Residual chemical will stick to the container and can
cause the detergent injector to clog and not function
properly.
• Remove high pressure hose from spray gun.
• Remove lance from the gun. Place the gun in the
holder on the side. Lances are placed into any of the
slots in the back of the unit. Make sure to discard
any remaining detergent from the bottle. Flush the
bottle and nozzle head with fresh water to prevent
clogging.
• Hook the power cord around the L-shaped tabs on
the right side of the machine when facing it.