CPSIA#2-E800FS1010- -MW
H9 - 12 x 3.5mm Phillips Round Head Screw (56) H14 - 8.
Must be flush Important note: Groove from Parts J, N & L must be align before tighten H1 bolts. Support block must face down Important note: Do NOT tighten H5 bolts. Finger tighten only.
Important note: Groove from Parts J, N & L must be align before slide Part R into groove.
Must be flush
Phillips Round Head Screw (H9). H9 H9 Phillips Round Head Screw - 16 pcs H9 H9 H9 H9 H9 H9 Important note: H9 Screws must be screwed straight. H9 H9 H9 H9 H9 H9 H9 H9 H9 H9 Must be flush Note: Cutting edge on all Parts C & D must face down Must be flush Recommended: It is suggested but not required to use a small amount of wood glue on all wood dowel pins.
Important note: This step requires help from another adult. Recommended: It is suggested but not required to use a small amount of wood glue on all wood dowel pins.
2 pcs 5
Attach Upper Cabinet Assembly to Lower Cabinet Assembly using 4 pcs Allen Head Bolts (H13), 4 pcs Flat Washer (H14) and 4 pcs Phillips Flat Head Bolts (H1) See Figure 10. Tighten, but do Not over tighten or strip our H14 & H1 Bolts.
Phillips Round Head Screw (H9). H9 Phillips Round Head Screw - 26 pcs Top Part F must flush with bottom part of Part S.
Ref Part# Description Qty A E800FS1010-A Lower Left Side Panel 1 B E800FS1010-B Lowe Right Side Panel 1 C E800FS1010-C Top & Bottom Shelves 2 D E800FS1010-D Middle Shelves 2 E E800FS1010-E Base Cross Panel 1 F E800FS1010-F Lower Back Cover 1 G E800FS1010-G Door Panel 1 J E800FS1010-J Upper Left Side Panel 1 K E800FS1010-K Upper Right Side Panel 1 L E800FS1010-L Upper Section Bottom Panel 1 M E800FS1010-M Dartboard Anchor Panel 2 N E800FS1010-N Upper Panel 1
