User's Manual
Table Of Contents
- Contents
- About This Manual
- Chapter 1 Introduction
- Chapter 2 Basic Installation and Configuration
- Wireless Equipment Placement and Range Guidelines
- Understanding MaxR-3210 Wireless Security Options
- Installing the MaxR-3210 Wireless Access Point
- Logging In Using the Default IP Address
- Setting Basic IP Options
- Wireless Settings
- Setting Up and Testing Basic Wireless Connectivity
- Understanding Security Profiles
- SSID and WEP/WPA Settings Setup Form
- Configuring the RADIUS Server Settings
- Setting up a Security Profile
- Configuring WEP
- Configuring WPA with RADIUS
- Configuring WPA2 with RADIUS
- Configuring WPA and WPA2 with RADIUS
- Configuring WPA-PSK
- Configuring WPA2-PSK
- Configuring WPA-PSK and WPA2-PSK
- Restricting Wireless Access by MAC Address
- Chapter 3 Management
- Remote Management
- Remote Console
- Upgrading the Wireless Access Point Software
- Configuration File Management
- Changing the Administrator Password
- Enabling the SysLog Server
- Using Activity Log Information
- Viewing General Summary Information
- Viewing Network Traffic Statistics
- Viewing Available Wireless Station Statistics
- Enabling Rogue AP Detection
- Viewing Rogue AP Statistics
- Packet Capture
- Chapter 4 Advanced Configuration
- Chapter 5 Troubleshooting and Debugging
- No lights are lit on the Access Point.
- The Wireless LAN activity light does not light up.
- The LAN light is not lit.
- I cannot access the Internet or the LAN with a wireless capable computer.
- I cannot connect to the MaxR-3210 to configure it.
- When I enter a URL or IP address I get a timeout error.
- Using the Reset Button to Restore Factory Default Settings
- Appendix A Default Settings and Technical Specifications
- Appendix B Command Line Reference
- Index
MaxR-3210 Wireless-N Access Point User Manual
6 Arada Systems Confidential
v1.1, Dec 2009
2.
Restore to Factory Defaults Button
The restore to default button is located next to the RJ-45 console port and restores the MaxR-
3210 to the factory default settings.
3. Serial Console Port
RJ-45 serial console port for serial DTE connections.
4. RJ-45 Ethernet Port
Use the MaxR-3210 Ethernet RJ-45 port to connect to an Ethernet LAN through a device such
as a hub, switch, router, or PoE switch.
5. Power Socket
This socket connects to the MaxR-3210 12V 1.5A power adapter.