Installation manual

22
Villager Esprit Stove
SERVICE & MAINTENANCE
Please Note—This should be carried out when
the fire is cold and unlit.
DOOR PRIMARY AIR INLET
A yearly check is required to inspect the primary
air inlet assembly, located on the rear of the main
fire door.
 Once the appliance is unlit and cold, open
the main fire door .
 Clean off any ash or tar residue from the
inside face of the rear of the door.
 Working from the front, unscrew the control
knob, whilst holding the slider on the inside.
 Withdraw the slider and inspect / clean the
mating face and the inside face of the door
casting.
 Replace the slider if damaged or warped
 Reverse the instructions for the refitting.
Fig. 14. Positioning The Glass
Fig. 15. Tightening The Glass Clip
Fig. 16. Inspection Of The Primary Slider
USE ONLY HAND TOOLS TO
TIGHTEN THE GLASS FIXINGS
The glass clips should be hand tightened only
Ensure this gap is equal top
and bottom, approx 2.5mm
Approx 2.5mm