User Instructions

ArapahoTechnologiesInc. LiquidAider™ DraftMay2019Instructions
5. Put on your hydration backpack.
6. Put on your helmet and attach the magnet disconnect backflow preventer. The
magnetic disconnect back flow preventer will mate easily due to the magnets.
It also disconnects easily when you remove your helmet.
7. Pull the helmet tube from the nozzle and suck on it to raise water through the
pump and through the backflow connector. This keeps the pumped primed and
eliminates air from the pump. The pump is not self-priming. Always make
sure water is in the tube above the pump before using.
8. Slide the helmet tube back into the nozzle.
9. Push the button on the handlebar. Water will squirt out the nozzle. Adjust the
nozzle tip with your fingers to get the desired aim.
GO RIDE!
Here is a small child’s riding setup.