User Instructions

ArapahoTechnologiesInc. LiquidAider™ DraftMay2019Instructions
PUMP OPERATIONAL NOTES
The pump battery will stay on for 4 hours. If the pump is being used, then it will
stay on for 4 hours after last use.
Even allowing the pump battery to time out, your pump battery should last for most,
if not all, of its normal capacity of 40 liters of pumped water.
BATTERY OPERATIONAL NOTES
The button battery (CR2032 coin cell) should last you a riding season even with
frequent use. The pump battery needs recharging after about 40 liters of water
pumped.
The button LEDs report low battery conditions for the button battery and the pump
battery when the trigger button is pressed:
 If while being used, the top LED blinks multiple times, then the button battery
is at 25% remaining capacity. This is still quite a lot of capacity so you can
probably still use the battery for up to a few months. But don’t push your luck.

If while being used, the bottom LED blinks multiple times, the pump battery
is at 25% remaining capacity. You probably have about 10 liters of pump use.
To change the button battery, remove the button cap and slide out the old CR2032
battery. Note the larger flat side, the positive side, is on the right side when being
installed. Simply reverse the battery if you find that you installed it backwards
.