Mobile ID Terminal- Marshall Operational Manual
V 1.0 Table OF CONTENTS: 1. Introduction………………………………………………………………………….….3 2. Important Safety Information…………………………………………….…….3 3. Product Interface………………………………………………………………….….4 4. Operations……………………………………………………………………………….7 5. Troubleshooting ………………………………………………………………………10 6.
Introduction Portable. Powerful. Versatile. The ARATEK MARSHALL is an all-in-one device for easy identification and Portable. Powerful. Versatile. The ARATEK MARSHALL is an all-in-one device for easy identification and authentication anywhere. It is designed for demanding conditions that require portability and accuracy.
Product Interface Model Name: Marshall Specs: FAP20 FPR, NFC, Printer, MRZ, 10000mAh Battery, 3G/4G,2D barcode, SCR
Operations Before switching ON Marshall for the first time or after a long time period, put it on charging until full power. 1.Charge Even if the device is not switched ON, the battery will be charged whenever the DC Adaptor power is available. Red/green indicator light: red light when power charging is less than 90%; green light when power charging is greater than or equal to 90%.
2.On/Off operation 3.
4.
Troubleshooting Problem 1: charge failure Solution: (1) Check if the plug is inserted correctly. (2) Ensure that micro USB charging port has good contact. Problem 2: heating Solution: Avoid using the device under too hot environment. Stop device operation for a while. Problem 3: crash Solution: a. Long press power button to turn off, then turn on. b. Press reset button to restart device. c. Contact SMARTMATIC support team. Problem 4: Other problems Solution: Contact Aratek for support, website: www.aratek.
Basic Operating System Android 8.1 Processor MT8735 Quad-core 1.3GHz Memory 2G RAM + 16G ROM Display 5 Inches 720*1280 Pixels IPS LCD Resolution 720*1280 IPS Camera 13 MP Auto Focus (Rear) Expansion Card TF Card, Up to 64G Printer (option) 2 Inches Thermal Printer Battery 10000 mAh/3.
FCC Statement 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. 2. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
it must be tested and certified to the FCC that it does not exceed the limit established by the government adopted requirement for safe exposure. The tests are performed in positions and locations (e.g., at the ear and worn on the body) as required by the FCC for each model. The maximum scaled SAR in front of face is 0.225W/Kg and extremity is 1.158W/Kg.