Replacement Part List

2
ARCH TO BASE ASSEMBLY
Landscape Screen Arch
Place the arch panel on top of the base panel centered over the
top rail. Make sure the lath patterns match.
Use the 2 1/2” screws to secure the arch panel to the base
panel through the 4 predrilled holes.
Be sure to let the screws follow the angle of the pre-drilled
holes.
INSTALLATION
Screens are equipped with (2) 36” Steel Stakes for in-ground, freestanding installation.
These can be mounted to either the side or back of the Base Panel.
Placement of Stakes
If mounting the Stakes on the back of the Base Panel, drive the first stake 14” to 18” into
the ground in the desired location. Be sure to position the stake such that the “U” shape
faces the Panel. Measure 34” apart from this first stake and then drive your second stake
14” to 18” into the ground.
If mounting the Stakes on the side of the Base Panel, drive the first stake 14” to 18” into
the ground in the desired location. Measure 36.5” from this first stake, then drive your
second stake 14” to 18” into the ground.
If attaching Wing Panels to Base Panel stakes will need to be attached from the back.
Attaching Base Panel to Stakes
We recommend installing the screen so that the bottom of the posts are 1” above the
ground.
Use the 1 5/8” wood screws to secure the screen to the stakes. Screw through the holes
in the stake into the Panel frame and be sure to use the highest and lowest possible holes
on each stake.
Arch Top Panel
Rectangular Base Panel
Wood Screws - 2 1/2” (4)
Driver bit (if other than Phillips head)
Stakes (2) & Wood Screws - 1 5/8” (4)
CHECK BOX FOR THESE CONTENTS
Arch Panel
Base Panel