Instruction manual

11 Maintenance
✓
✗
Fig.18
Not tensioned
Fig.17
Small
Pulley
Fig.19
Tensioning or replacing the belt
•
Unplug the Mini-grinder
•
Remove the 4 belt tensioning cap screws (shown in fig. 17).
•
Then remove the 3 top cover screws (see knowing your tool page 5)
•
Remove all visible slack from the belt by turning the tensioning cap. (shown correctly
in fig.18). Rotate the belt tensioning cap in the direction in which the blade moves
away from the guard (see fig.17). The blade can be seen moving slightly when
rotating the Belt tensioning cap.
•
When tensioned secure with top cover screws.
DO NOT OVER TENSION THE BEL
T
If replacing the belt ensure that the “V” shape sides of the belt are on the inside (as shown
in fig.19). Replacement belts (MIN003) are available through Arbortech Pty Ltd
(see address on back).
Note: clean with a soft cloth or small brush.
Belt
Tensioning Cap
“V” Belt
Guard
Slack removed and tensioned