Installation Guide

36.00
INCLINE
36.00
FLAT
MOUNTING CENTER TO
CENTER DISTANCE
FOR STANDARD STUD WALLS, MEASURE THE CENTER TO
CENTER DISTANCE OF TWO STUDS THAT FALL WITHING THE
LENGTH OF YOUR HANDRAIL. FOR HANDRAILS GREATER
THAN 5FT, MORE THAN TWO MOUNTING POINTS WILL BE
REQUIRED. THESE MOUNITING LOCATIONS MUST BE EQUAL
DISTNACES APART.
EQUAL DISTANCE FROM
END OF HANDRAIL
LOCATE MOUNTING POINTS
DETERMINE THE HEIGHT OF YOUR HANDRAIL
THIS DIMENSION SHOULD BE APPROXIMATELY 36" OFF THE
FLOOR. IF THE HANDRAIL IS TO BE MOUNTED OVER A
SECTION OF STAIRS, OR INCLINE SURFACE, KEEP THE
HANDRAIL PARALLEL TO THE SLOPE.
DATE: 10/2/2017 REV. #1
HANDRAIL INSTALLATION GUIDE
CONTACT INFO:
WEB ADDRESS: [e-mail]
MATERIAL LIST
NOTE: BE CAUTIOUS OF OBSTRUCTIONS
BEHIND THE MOUNTING SURFACE. ARC AND HAMMER IS NOT
LIABLE FOR FAILURE DUE TO INADEQUATE MOUNTING
LOCATIONS.
WHEN POSITIONING THE WALL BRACKETS IT IS BEST TO KEEP
THEM EQUAL DISTANCE FROM THE ENDS OF THE HANDRAIL.
BE SURE TO MAINTAIN THE "MOUNTING CENTER TO CENTER
DISTANCE" FROM STEP #2.
POSITION WALL BRACKETS ON THE HANDRAIL
1
2
3
6126 12'
5105 11'
5105 10'
484 9'
484 8'
363 7'
363 6'
242 5'
242 4'
242 3'
242 2'
LAG
BOLTS
SHEET METAL
SCREWS
# OF
BRACKETS
HANDRAIL
LENGTH