Instruction Manual

Flex HANDY Instruction Manual
June 2019 v1.0
Page 13 of 34
PB1
PB2
PB1
PB2
4.1.3 Remote Pairing
A. Transmitter-to-Transmitter Pairing:
1) Press down the STOP button (transmitter power off).
2) Set dipswitch position #7 to “0” (down) and #8 to “1” (up).
3) Reset the STOP button by rotating it clockwise or counter clockwise, it will pop up
(transmitter power on).
4) The Status LED displays firmware version with red, green and orange blinks.
5) Output data (original transmitter) by press and hold PB2 (Status LED off).
6) Receive data (new transmitter) by press and hold PB1 (Status LED blinks green).
7) When the Status LED (receiving data end) turns to constant green while both
pushbuttons are still pressed down, the pairing is completed.
8) Exit Remote Pairing mode by resetting the dipswitch position #7 and #8 back to “00”
(both down) and press down the STOP button (transmitter power off).
→
Output data – original transmitter Receive data – new transmitter
(press and hold PB2) (press and hold PB1)
Note: During remote pairing make sure the distance between the two transmitters is within 1 meter.
ON DIP