Instruction Manual

Flex HANDY Instruction Manual
June 2019 v1.0
Page 14 of 34
ON DIP
S2 DIP 10
PB1
PB2
ON DIP
B. Receiver-to-Transmitter Pairing (Press PAIRING button required):
1) Press down the STOP button (transmitter power off).
2) Set dipswitch position #7 to “1” (up) and #8 to “0” (down).
3) Reset the STOP button by rotating it clockwise or counter clockwise, it will pop up
(transmitter power on).
4) The Status LED displays firmware version with red, green and orange blinks.
5) S2 dipswitch position #10 in receiver set to “0” (down).
6) Output data by press and hold the PAIRING button on receiver.
7) Receive data by press and hold PB1 on the transmitter (Status LED blinks green).
8) When the transmitter Status LED (receiving data end) turns to constant green while
both pushbuttons are still pressed down, the pairing is completed.
9) Exit Remote Pairing mode by resetting the transmitter dipswitch position #7 and #8
back to “00” (both down) and press down the STOP button (transmitter power off).
→ →
S2 dipswitch position 10 set to “0” Output data – receiver Receiving data – transmitter
(press and hold the Pairing button) (press and hold PB1)