Instruction Manual

Flex HANDY Instruction Manual
June 2019 v1.0
Page 15 of 34
ON DIP
PB1
PB2
ON DIP
C. Receiver-to-Transmitter Pairing (Press PAIRING button not required):
1) Press down the STOP button (transmitter power off).
2) Set dipswitch position #7 to “1” (up) and #8 to “0” (down).
3) Reset the STOP button by rotating it clockwise or counter
clockwise, it will pop up (transmitter power on).
4) The Status LED displays firmware version with red, green
and orange blinks.
5) S2 dipswitch position #10 in receiver set to “1” (up).
6) Receive data by press and hold PB1 on the transmitter
(Status LED blinks) until the Status LED turns to constant
green, the pairing is completed.
7) Make sure the pairing process is executed within
distance of 10 meters from one another and no other
active receivers nearby. During pairing process, the receiver MAIN relays
8) Exit Remote Pairing mode by resetting the transmitter dipswitch position #7 and #8
back to “00” (both down) and press down the STOP button (transmitter power off).
D. Transmitter-to-Receiver Pairing (Press PAIRING button required):
1) Press down the STOP button (transmitter power off).
2) Set dipswitch position #7 to “1” (up) and #8 to “0” (down).
3) Reset the STOP button by rotating it clockwise or counter
clockwise, it will pop up (transmitter power on).
4) The Status LED displays firmware version with red, green
and orange blinks.
5) Output data by press and hold PB2 on the transmitter
(Status LED off)
6) Receive data by press and hold the PAIRING button on
receiver.
7) When the transmitter Status LED turns to constant green
while both pushbuttons are still pressed down, the pairing
is completed.
8) Exit Remote Pairing mode by resetting the transmitter dipswitch position #7 and #8
back to “00” (both down) and press down the STOP button (transmitter power off).
→
Output data – transmitter Receiving data – receiver
(press and hold PB2) (press and hold the Pairing button)