Owner's Manual
Table Of Contents
- Handbook
- Factory Default Reset
- Important safety instructions
- Contents
- Before you begin…
- Rear panel connectors
- Audio/video connections
- Radio connectors
- Other connectors
- Speakers
- Operation
- Front panel operation
- Remote control
- Essential setup
- Auto speaker setup
- Setup menus
- Decoding modes
- Tuner operation
- Network/USB operation
- Multi-room set up
- Customising the remote
- Troubleshooting
- Specs
- Product guarantee
- Device Code Tables
E-46
SR250
Continuous power output, per channel, 8
2 channels driven, 20Hz - 20kHz, <0.02% THD 90W
2 channels driven, 1kHz, 0.2% THD 125W
Residual noise & hum (A-wtd) <0.15mV
Stereo line inputs
Maximum input 4.5V rms
Nominal sensitivity 1V, 2V, 4V (user adjustable)
Input impedance 47kΩ
Signal/noise ratio (A-wtd ref 95W) normal/stereo direct 100dB/110dB
Frequency response 20Hz—20kHz ± 0.2dB
Preamplier outputs
Nominal output level 1V RMS
Output impedance 560Ω
THD+N (20Hz—20kHz) -100dB
Headphone output
Maximum output level into 32Ω 2Vrms
Output impedance <5Ω
General
Mains voltage 110–120V or 220–240V, 50 –60Hz
Power consumption (maximum) 600W (ermal dissipation approx. 2040 BTU/hour)
Power consumption (idle, typical) 100W (ermal dissipation approx. 340 BTU/hour)
Power consumption (standby) <0.5W
Dimensions
W x D (including speaker terminals) x H (including feet)
433 x 425 x 171mm
Weight (net) 15.1kg
Weight (packed) 18.5kg
Supplied accessories Mains lead
Remote control
2 x AAA batteries
Manual
FM aerial
Calibration microphone
USB cable
E&OE
NOTE: All specication values are typical unless otherwise stated.