Owner's Manual
Table Of Contents
- Handbook
- Factory default reset
- Safety Guidelines
- Welcome
- Contents
- Before You Begin
- Trademark Acknowledgments
- Rear Panel Connections and Controls
- Audio/Video Connections
- Connection Guide
- Radio & Wireless Audio Connectors
- Other Connectors
- Speakers
- Connecting Speakers
- Operation
- Extended front panel menu
- Front Panel Operation
- Remote Control
- Device Mode/Source keys
- Customising the Remote
- Essential Setup
- Auto Speaker Setup
- Setup Menus
- Connecting to a Network
- Decoding Modes
- Tuner Operation
- Troubleshooting
- Specifications
- Device Code Tables
- Custom Installation Notes
- Contents
- Introduction
- Set-up
- Conventions
- Serial Cable Specification
- Example command and response sequence
- System Command Specifications
- Input Command Specifications
- Output Command Specifications
- Menu Command Specifications
- Setup Adjustment Command Specifications
- Treble Equalisation (0x35)
- Bass Equalisation (0x36)
- Room Equalisation (0x37)
- Dolby Volume (0x38)
- Dolby Leveller (0x39)
- Dolby Volume Calibration Offset (0x3A)
- Balance (0x3B)
- Subwoofer Trim (0x3F)
- Lipsync Delay (0x40)
- Compression (0x41)
- Request incoming video parameters (0x42)
- Request incoming audio format (0x43)
- Request incoming audio sample rate (0x44)
- Set/Request Sub Stereo Trim (0x45)
- Set/Request Zone 1 OSD on/off (0x4E)
- Set/Request Video Output Switching (0x4F)
- Set/request input name (0x20)
- FM Scan up/down (0x23)
- DAB Scan (0x24)
- Heartbeat (0x25)
- Reboot (0x26)
- Bluetooth status (0x50)
- Setup (0x27)
- Room EQ name(s) (0x34)
- Now Playing Information (0x64)
- Input config (0x28)
- General Setup (0x29)
- Speaker Types (0x2A)
- Speaker Distances (0x2B)
- Speaker Levels (0x2C)
- Video Inputs (0x2D)
- HDMI settings (0x2E)
- Zone settings (0x2F)
- Network (0x30)
- Bluetooth (0x32)
- Engineering menu (0x33)
- AV RC5 command codes
- Product Info
- Mandatory Software Update
- Software Release Notes
- Warranty & Product Registration
EN
EN-41
Continuous power output, per channel, 8/4
2 channels driven, 20Hz - 20kHz, <0.02% THD
110W/175W
2 channels driven, 1kHz, 0.2% THD
125W/190W
7 channels driven, 1kHz, 0.2% THD
90W/110W
Residual noise & hum (A-wtd)
<0.15mV
Stereo line inputs
Maximum input
4.5V rms
Nominal sensitivity
1V, 2V, 4V (user adjustable)
Input impedance
47kΩ
Signal/noise ratio (A-wtd ref 100W) normal/stereo direct
100dB/110dB
Frequency response
20Hz—20kHz ± 0.2dB
Preamplier outputs
Nominal output level
1V RMS (max. 5V RMS)
Output impedance
560Ω
THD+N (20Hz—20kHz)
–100dB
Headphone output
Maximum output level into 32Ω
5Vrms
Output impedance
<100Ω
General
Mains voltage
110–120V or 220–240V, 50 –60Hz
Power consumption (maximum)
1.5kW (Thermal dissipation approx. 5200 BTU/hour)
Power consumption (idle, typical)
100W (Thermal dissipation approx. 340 BTU/hour)
Power consumption (standby)
<0.5W
Dimensions W x D
(including speaker terminals) x H (including feet)
433 x 425 x 171mm
Weight (net)
16.6kg
Weight (packed)
19.9kg
Supplied accessories
Mains lead
Remote control with 2 x AAA batteries
Manual
DAB/FM aerial
3 x WiFi/Bluetooth antennas
Calibration microphone
USB cable
E&OE
NOTE: All specification values are typical unless otherwise stated.
AVR20
Continuous power output, per channel, 8/4
2 channels driven, 20Hz - 20kHz, <0.02% THD
80W/100W
2 channels driven, 1kHz, 0.2% THD
85W/120W
7 channels driven, 1kHz, 0.2% THD
60W/85W
Residual noise & hum (A-wtd)
<0.15mV
Stereo line inputs
Maximum input
4.5V rms
Nominal sensitivity
1V, 2V, 4V (user adjustable)
Input impedance
47kΩ
Signal/noise ratio (A-wtd ref 100W) normal/stereo direct
100dB/110dB
Frequency response
20Hz—20kHz ± 0.2dB
Preamplier outputs
Nominal output level
1V RMS (max. 5V RMS)
Output impedance
560Ω
THD+N (20Hz—20kHz)
–100dB
Headphone output
Maximum output level into 32Ω
5Vrms
Output impedance
<100Ω
General
Mains voltage
110–120V or 220–240V, 50 –60Hz
Power consumption (maximum)
1.5kW (Thermal dissipation approx. 5200 BTU/hour)
Power consumption (idle, typical)
90W (Thermal dissipation approx. 340 BTU/hour)
Power consumption (standby)
<0.5W
Dimensions W x D
(including speaker terminals) x H (including feet)
433 x 425 x 171mm
Weight (net)
16.5kg
Weight (packed)
19.8kg
Supplied accessories
Mains lead
Remote control with 2 x AAA batteries
Manual
DAB/FM aerial
3 x WiFi/Bluetooth antennas
Calibration microphone
USB cable
E&OE
NOTE: All specification values are typical unless otherwise stated.
AVR10