Owner's Manual
Table Of Contents
- Handbook
- Factory default reset
- Safety Guidelines
- Welcome
- Contents
- Before You Begin
- Trademark Acknowledgments
- Rear Panel Connections and Controls
- Audio/Video Connections
- Connection Guide
- Radio & Wireless Audio Connectors
- Other Connectors
- Speakers
- Connecting Speakers
- Operation
- Extended front panel menu
- Front Panel Operation
- Remote Control
- Device Mode/Source keys
- Customising the Remote
- Essential Setup
- Auto Speaker Setup
- Setup Menus
- Connecting to a Network
- Decoding Modes
- Tuner Operation
- Troubleshooting
- Specifications
- Device Code Tables
- Custom Installation Notes
- Contents
- Introduction
- Set-up
- Conventions
- Serial Cable Specification
- Example command and response sequence
- System Command Specifications
- Input Command Specifications
- Output Command Specifications
- Menu Command Specifications
- Setup Adjustment Command Specifications
- Treble Equalisation (0x35)
- Bass Equalisation (0x36)
- Room Equalisation (0x37)
- Dolby Volume (0x38)
- Dolby Leveller (0x39)
- Dolby Volume Calibration Offset (0x3A)
- Balance (0x3B)
- Subwoofer Trim (0x3F)
- Lipsync Delay (0x40)
- Compression (0x41)
- Request incoming video parameters (0x42)
- Request incoming audio format (0x43)
- Request incoming audio sample rate (0x44)
- Set/Request Sub Stereo Trim (0x45)
- Set/Request Zone 1 OSD on/off (0x4E)
- Set/Request Video Output Switching (0x4F)
- Set/request input name (0x20)
- FM Scan up/down (0x23)
- DAB Scan (0x24)
- Heartbeat (0x25)
- Reboot (0x26)
- Bluetooth status (0x50)
- Setup (0x27)
- Room EQ name(s) (0x34)
- Now Playing Information (0x64)
- Input config (0x28)
- General Setup (0x29)
- Speaker Types (0x2A)
- Speaker Distances (0x2B)
- Speaker Levels (0x2C)
- Video Inputs (0x2D)
- HDMI settings (0x2E)
- Zone settings (0x2F)
- Network (0x30)
- Bluetooth (0x32)
- Engineering menu (0x33)
- AV RC5 command codes
- Product Info
- Mandatory Software Update
- Software Release Notes
- Warranty & Product Registration
29
General Setup (0x29)
Sends general setup menu info.
COMMAND:
Byte: Description:
St 0x21
Zn 0x01
Cc 0x29
Dl 0x01 / 0x21
Data1
Data 1-32
0xF0 - request Input config
set input config as below
Et 0x0D
RESPONSE:
Byte: Description:
St 0x21
Zn Zone Number
Cc 0x29
Ac Answer code
Dl 0x21
Data1-10
Data11
Data12
0xnn - Input name in ASCII characters
Audio stream format:
0x00 – PCM
0x01 – Analogue Direct
0x02 – Dolby Digital
0x03 – Dolby Digital EX
0x04 – Dolby Digital Surround
0x05 – Dolby Digital Plus
0x06 – Dolby Digital True HD
0x07 – DTS
0x08 – DTS 96/24
0x09 – DTS ES Matrix
0x0A – DTS ES Discrete
0x0B – DTS ES Matrix 96/24
0x0C – DTS ES Discrete 96/24
0x0D – DTS HD Master Audio
0x0E – DTS HD High Res Audio
0x0F – DTS Low Bit Rate
0x10 – DTS Core
0x13 – PCM Zero
0x14 – Unsupported
0x15 – Undetected
0x16 - Dolby Atmos
0x17 - DTS:X
0x18 - IMAX ENHANCED
0x19 - Auro 3D
Audio channel configuration:
0x00 – Dual Mono
0x01 – Centre only
0x02 – Stereo only
0x03 – Stereo + mono surround
0x04 – Stereo + Surround L & R
0x05 – Stereo + Surround L & R + mono Surround Back
0x06 – Stereo + Surround L & R + Surround Back L & R
0x07 – Stereo + Surround L & R containing matrix information for surround
back L&R
0x08 – Stereo + Centre
0x09 – Stereo + Centre + mono surround
0x0A – Stereo + Centre + Surround L & R
0x0B – Stereo + Centre + Surround L & R + mono Surround Back
0x0C – Stereo + Centre + Surround L & R + Surround Back L & R
0x0D – Stereo + Centre + Surround L & R containing matrix information for
surround back L&R
0x0E – Stereo Downmix Lt Rt
0x0F – Stereo Only (Lo Ro)
0x10 – Dual Mono + LFE
0x11 – Centre + LFE
0x12 – Stereo + LFE
0x13 – Stereo + single surround + LFE
0x14 – Stereo + Surround L & R + LFE
0x15 – Stereo + Surround L & R + mono Surround Back + LFE
0x16 – Stereo + Surround L & R + Surround Back L & R + LFE
0x17 – Stereo + Surround L & R + LFE
0x18 – Stereo + Centre + LFE containing matrix information for
surround back L&R
0x19 – Stereo + Centre + single surround + LFE
0x1A – Stereo + Centre + Surround L & R + LFE (Standard 5.1)
0x1B – Stereo + Centre + Surround L & R + mono Surround Back + LFE
(6.1, e.g. DTS ES Discrete)
0x1C – Stereo + Centre + Surround L & R + Surround Back L & R + LFE (7.1)
0x1D – Stereo + Centre + Surround L & R + LFE, containing matrix
information for surround back L&R (6.1 e.g. Dolby Digital EX)
0x1E – Stereo Downmix (Lt Rt) + LFE
0x1F – Stereo Only (Lo Ro) + LFE
0x20 – Unknown
0x21 – Undetected